On a 89 wagoneer where is the the reverse light switch on the trans or in the steering column? I put in a th 400 tran and don't see any wire on trans.
reverse light
Collapse
X
-
On a 727 the swith is on the drivers side of the trans just above the pan. TH400 it is in the column.Kaiser - 1981 J20 115" WB - 5.3l/4l60E/np241c/3-link hp60 spooled/Leafs 14-bolt detroit/5.13's/40's
Build Thread
Fight Crime...Shoot Back.
ΜΟΛΩΝ ΛΑΒΕ
-
-
Let me check some books. I'll post up here in a few minutes...
Where there's a will there's a waiver, I mean a way...
Back: I'm checking to see if the switch assembly for a mid 80s K20 is a direct fit or not...it's taking a little bit...Last edited by REDONE; 12-21-2010, 08:32 PM.2012 Winner of the Prestigious Ouray Cast Iron Butt Award
79 J-10 - The Money Badger!
304/T18/D20/D44s
What's been did:
Holley 4160/Ede' S.P.2.P.
MSD Streetfire based TFI
Custom-hack gauge cluster
Razor swap
Fancy exhaust (Thrush Muffler)
2 knob tape deck!
3" homebuilt lift
Half a hillbilly paint job
Comment
-
-
Its too dark and dirty out in the shed, but I got a 86 column out back, I'll dig it out and see if it's got provisions for the switch tomorrow.2012 Winner of the Prestigious Ouray Cast Iron Butt Award
79 J-10 - The Money Badger!
304/T18/D20/D44s
What's been did:
Holley 4160/Ede' S.P.2.P.
MSD Streetfire based TFI
Custom-hack gauge cluster
Razor swap
Fancy exhaust (Thrush Muffler)
2 knob tape deck!
3" homebuilt lift
Half a hillbilly paint job
Comment
-
-
If it dont have provisions for a switch, surely there is something there to make a bracket fit on to it. I know the wiring is simple enough.modified flares, removable top, OBA w/200psi tank,
LQ4, 4L80e,NWF doubler w/upside down 203
SOA w/ D44s F+R for now
H1 wheels+tires (cut), hydroboost brakes
custom shackle flip W/F150 springs
-----Coming Soon-----
snorkels,
OX'd D60/14B-FF
Comment
-
-
Sorry it took a couple days more than I intended!
The factory GM holes are there but the little piece to hold the switch pin and the switch mounting plate and screw holes are missing:
My best recommendation at this time is to find a matching color steering column from a 3 speed auto chevy truck and install it with your steering wheel, or get an aftermarket floor shifter with the back up light wiring in it. Or go super cheap and easy and just wire it to a dash switch and turn them on when you need them...2012 Winner of the Prestigious Ouray Cast Iron Butt Award
79 J-10 - The Money Badger!
304/T18/D20/D44s
What's been did:
Holley 4160/Ede' S.P.2.P.
MSD Streetfire based TFI
Custom-hack gauge cluster
Razor swap
Fancy exhaust (Thrush Muffler)
2 knob tape deck!
3" homebuilt lift
Half a hillbilly paint job
Comment
-
Comment