I spent some decent time ensuring the exhaust ports are matched to the exhaust gaskets. I was not able to port match the header flange though because the header had too much movement relative to the gasket. But now that they have run for a while you can see how terribly they match the exhaust ports! These are probably killing TONS of flow. I guess that's what I get for a set of headers this cheap.
Anyway, would you take a die grinder to these to hog them out a little? I am worried that I will eat through the tube and create leaks. At the same time, some of these exhaust ports are really bad...
Anyway, would you take a die grinder to these to hog them out a little? I am worried that I will eat through the tube and create leaks. At the same time, some of these exhaust ports are really bad...
Comment