Does anyone reproduce the drivers door VIN decal? If so where can I get one made.
reproduction door VIN decal
Collapse
X
-
Thanks, that is what I was looking for. I did a little searching on the line but did not like what I found.1978 Wagoneer
401/turbo 400 trans. Quadra-Trac BW1339 (with Low) 4" Rusty's lift with 31" Summit Mud Dawgs
Mods:
Fuel Tank, Red Holley Fuel Pump, Razor Grill (profile pic out dated), Rebuilt steering box
Comment
-
-
perhaps this is a grey area? i would weigh the consequences of the penalty if there is any trickery involved? just because they make them does NOT get you off the hook. i would imagine even if its a exact duplicate of the original one its not "the" original VIN sticker
just a thought......Abort? Retry? Ignore? >
86 GrandWag. Howell fuel Injected 360. MSD Ignition + Dizzy. 727/229 swap BJ's 2" Lift and 31's
88 Wrangler 4.2, Howell TBI and MSD - Borla Headers w/ Cat-back + winch and 31's AND a M416 trailer (-:
Comment
-
-
On Mopar's the outfit ( ESC Automotive ) that does it is licensed through Chrysler. they are perfect. for Jeep it would have to be licensed through Chrysler as well to be legal. I'm not sure if they do Jeep or not.
Even then they will only reproduce a door VIN sticker if you send them a clear picture of the original.
Comment
-
-
Thanks for the replies, 440 I think it is ECS Automotive if anyone is interested. The only reason I'am asking is that mine is in really bad shape and hard to read. Not looking for any trickery or changes on the tag, just a nicer one for the restore. Also have never had any title transfer company come out and even eyeball a vehicle I was buying or selling, much less look at a door VIN sticker.1978 Wagoneer
401/turbo 400 trans. Quadra-Trac BW1339 (with Low) 4" Rusty's lift with 31" Summit Mud Dawgs
Mods:
Fuel Tank, Red Holley Fuel Pump, Razor Grill (profile pic out dated), Rebuilt steering box
Comment
-
-
Ordered my new VIN decal from Bearcreek. Said it could take 4 to 6 weeks, not going to be a problem for my build. As for the quality, I'am sure it will be as good as the factory ones. Which are not very good. This is what mine looked like before removal.
1978 Wagoneer
401/turbo 400 trans. Quadra-Trac BW1339 (with Low) 4" Rusty's lift with 31" Summit Mud Dawgs
Mods:
Fuel Tank, Red Holley Fuel Pump, Razor Grill (profile pic out dated), Rebuilt steering box
Comment
-
-
Originally posted by Full Size JeeperAlso have never had any title transfer company come out and even eyeball a vehicle I was buying or selling, much less look at a door VIN sticker.
There was a guy at that office whose job was validating VIN plates. Before going out to the car, he grabbed a book and jotted down a few notes. He knew where the VIN tag should be, how many rivets and where on the plate they should be, he measured the plate, and did a bunch of other checks. Anything older than 30 years has to go through that inspection when it comes into the state.
Comment
-
-
The stickers are not the legal VIN plate, and can be replaced as needed. They are just an informational sticker.
Now if you were to put something on that had a different VIN from your plate, thats another story.
My 80 sticker was completely worn away, you couldn't read anything on it.Ben
1980 Wagoneer - Ram Jet 350, 700R4, NP208, 4" lift, 33x10.5 tires.
Comment
-
-
Just received an e-mail on Monday the 28th that my VIN. has been shipped and should be here Thursday. Will post a pic when it gets here.1978 Wagoneer
401/turbo 400 trans. Quadra-Trac BW1339 (with Low) 4" Rusty's lift with 31" Summit Mud Dawgs
Mods:
Fuel Tank, Red Holley Fuel Pump, Razor Grill (profile pic out dated), Rebuilt steering box
Comment
-
-
Looking forward to pictures!Chuck McTruck 71 J4000
(Chuck McTruck Build Thread)
(8.1L swap questions - PerformanceTrucks.net Forums)
79 Cherokee Chief (SOLD, goodbye old buddy)
(Cherokee Build Thread)
11 Nissan Pathfinder Silver Edition 4x4
09 Mazdaspeed3 Grand Touring
00 Baby Cherokee
Comment
-
Comment