So I'm finally getting around to installing this TBI setup I got from Billygoat. I'm using a Hei dist. I converted over. I initially set the motor to TDC and then set the rotor to the trailing edge of #1 and lined up the reluctor per the instructions. Now my question is if the ecm base timing is set at 5deg rather then 0deg should I repeat all this with the engine at 5 deg from TDC or will it not matter. Thanks
Reluctor phasing
Collapse
X
-
Rotating the whole distr does not change the rotor/reluctor phasing if done correctly.
Just unplug the bypass and set the timing to 5* then reset byass and clear error codes.Bill USN-1
Fuel Injection Moderator at BinderPlanet
Hamilton Fuel Injection
75 scout XLC 345/727/JPD300/3.73's/33's/4wdisc/hydroboost/EFI/OBA/OBW
1977 Innocenti 1001 (Italian Mini)EFI 1275/DIS
-
Comment