http://i32.photobucket.com/albums/d4...ynuvwk1.jpeguu. Trying to figure out how to post pics from my iPhone, bare with me
69 wagon build
Collapse
X
-
69 wagon with matching m416
All original drive train, buick350, Dana 20, th400
51,000 original miles. Montana Jeep
Thanks to everyone who helped out with parts or advice or both! Special thanks to Al who always got back to me with advice and parts . We were building basically the same rig at the same time so it worked out nice for me. Let me know what you guys think, more pics to come
-
-
Door panel s and steering wheel
My first attempt at door panels. Started with men in blacks ABS panels that are great . Used a clear plastic template to transfer the mounting holes. Used a push through clip to mount to door. Clips are great for installing and removing panel with no problems, but I got a slight bulge in the vinyl where the fasteners are located. I should have counter sunk clips maybe?1969wagon/CA27C6A5-552A-4621-90FC-16C95590571E_zpszt4l0fwc.jpegLast edited by 69project; 03-22-2019, 12:07 PM.
Comment
-
-
Did you paint it? It is sooooooooooo straight! Wow! So many lines and flat panels on these rigs, it amazes me when people get them that straight.Chuck McTruck 71 J4000
(Chuck McTruck Build Thread)
(8.1L swap questions - PerformanceTrucks.net Forums)
79 Cherokee Chief (SOLD, goodbye old buddy)
(Cherokee Build Thread)
11 Nissan Pathfinder Silver Edition 4x4
09 Mazdaspeed3 Grand Touring
00 Baby Cherokee
Comment
-
-
Wow! Just wow! Looking super! I noticed the door seals. It sure is coming along. What a head turner for sure.Melford1972 says...
I’d say I feel sorry for you, but I really don’t, Mr. “I-stumble-into-X-models-the-way-most-people-stumble-into-Toyota-Carollas.” 🤣
-----------------------
I make wag parts
1969 CJ-5 41 years owned
1969 1414X Wag in avocado mist
1970 1414X Wag in avocado mist
1968 M715 restomod
2001 Dodge 3500
2002 Toyota Tundra
2006 Toyota 4runner was Liz's, parked
Building a m715 over at the m715zone
Beloved wife Elizabeth Ann Temple Murdered by covid on Oct 19th 2021
Small violin, large amp
Comment
-
-
Thanks Al, it runs real strong, shifts and stops great! I went through the harness and cleaned up 50 years of slight modifications, everything works now. I only need to Figure out the break warning light. Need to install tailgate then I’m going to register it and go fishing !
Comment
-
-
The tailgate tension rods were a bunch of fun. I found that having two helpers holding each end of the tailgate carefully bringing it forward in the near fully upright position (slightly higher that the door frame) allowed me to feed the rods into the hinge pockets without to much trouble. I had the hinges mounted in the door frame and carefully brought the tailgate to them after getting the rods in.
I taped cardboard on the body below and kraft paper on the sides to protect the paint. It is a bit of a nail biter but once in place it is super!
Good luck and catch those fish...Melford1972 says...
I’d say I feel sorry for you, but I really don’t, Mr. “I-stumble-into-X-models-the-way-most-people-stumble-into-Toyota-Carollas.” 🤣
-----------------------
I make wag parts
1969 CJ-5 41 years owned
1969 1414X Wag in avocado mist
1970 1414X Wag in avocado mist
1968 M715 restomod
2001 Dodge 3500
2002 Toyota Tundra
2006 Toyota 4runner was Liz's, parked
Building a m715 over at the m715zone
Beloved wife Elizabeth Ann Temple Murdered by covid on Oct 19th 2021
Small violin, large amp
Comment
-
Comment