If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thome, remove the hub from the spindle. Thread a steel nut with a 7/16 fine thread on to the stud until the nut is just a hair above the stud. Hit the nut until the stud backs out of the hub. I wouldnt use a chrome lug nut. Take one to a store and get a plain old nut.
Picture #3 shows the brake rotor separated from the hub, but from your description is sounds like that is what you are trying to get to.
If you are trying to get the wheel lug studs out, you have to put a nut, or two nuts if you are worried about damaging the threads, on the lug and hit it very hard. And you cannot use a soft face hammer, it will just give.
And if you have the studs out, but cannot separate the rotor from the hub, that is just some more hammer work.
If it is still a problem, you may want to re-evaluate your hammer choice. The bigger the better in this case.
Comment