His and Hers LS Swap Double Build

[His-N-Hers Woodies]

Next on the list...cross member

[His-N-Hers Woodies]

Fuel pump with level sending unit. Hoping this works. If not I may look for another sender and put another hole in the tanks.

[His-N-Hers Woodies]

Water pump drilled for steam lines.

[His-N-Hers Woodies]

Jeep oil sending units adapted to LS block

[His-N-Hers Woodies]

Evaporator is out until I can get hoses made. Ordered the fittings this morning.

[His-N-Hers Woodies]

Actually got fuel pumping! One step closer

[His-N-Hers Woodies]

Got lucky with the cross member! There was another set of mounting holes in the frame for it that lined up with the 4L60E. The driveline angle is close but may need some tweaking.

[His-N-Hers Woodies]

OK...things are starting to come together. The A/C is installed. New condenser, evaporator (for an '85 model, the one for an 89 didn't fit) and hoses crimped at Napa. Hopefully everything will gel with the LS compressor.

[His-N-Hers Woodies]

Just about done with the wiring

[His-N-Hers Woodies]

241C transfer case in. Going to attempt to use the stock shifter.

[His-N-Hers Woodies]

Opened up the rear diff but haven't started on it yet. Ordered G2 3.54:1 gears for it.

[His-N-Hers Woodies]

I have a mental map of how I will cobble together some old parts to make a drive shaft.

[His-N-Hers Woodies]

Any idea what to do with this thing (DOESN'T RUN) ? Are there desireable parts (headers, brackets, etc) or should it go to the scrap pile?

[rang-a-stang]

Any idea what to do with this thing (DOESN'T RUN) ? Are there desireable parts (headers, brackets, etc) or should it go to the scrap pile?

Timing covers always sell, Dizzy might get you a few bucks. Carbs are hit/miss (sometimes they go for $80, sometimes you can't give them away). The Evap cannistor would probably sell. I would put an ad up in the classified section saying you are parting it out and put a day that you are going to call the scrapper to come pick it up. I bet people will hit you up with some wanted items. I would say, at a minimum, pull the timing cover/oil pump. I MIGHT be interested in the Sanden A/C pump and brackets.

[His-N-Hers Woodies]

OK, here we go...
Radiator support back in place. Can't even tell I butchered it!