New Hydroboost Mounting Assembly Available

[Elliott]

Emailed you. I can be emailed at sterlingworth16 at yahoo
Thanks

Also, if anyone has a Toyota 4 Runner... say 2003+ with the electric master cylinder... I have a prototype hydroboost set up being tried out so these should be available. It requires going to a GM MC and adapting the existing brake lines to the ports on the GM MC but I can refer you to a source for adaptors. I will post pics of this when the guy verifies everything fits up well.

[Elliott]

Working on a Land Rover Defender 90 hydroboost application.... stay tuned.

[Elliott]

2003+ Toyota 4 Runner Hydroboost

This hydroboost replaces the $1,700 electric master cylinder. Shown installed on a slammed '03 4 Runner.

[Elliott]

European Toyota J7 Series Hydroboost

Here is one for our European friends, a '84+ Toyota J7 Series unit:

[Elliott]

Going to finish an install on a '64 Dodge Polara 500 today. Guy has a big block so it will requires rotating the hydroboost and adapting the MC to the rotation. This will fit the '62-'65 B and C Body.

[Elliott]

Ok, That guy's Polara rocks... pics of the completed install are coming.

I have a new mount figured out should fit in the '64.5-'66 Mustang and working on the '67-'70.

Somebody want to test fit this? Or I can find a local hot rodder...

[babywag]

I've got a '68 Mustang can help you if needed?
It's a blank slate right now, firewall is bare.
Booster is in the trunk I think?

[Elliott]

Ah great, the last measurement I need is from the two bolt holes opposite the 2" center hole through the firewall down to the bolt hole below directly under the 2" hole. It's either 2.1" or 2.3" from what I can tell and likely 2.3". The rest of it I have all mapped out. Post it here if you like or email me at sterlingworth16 at yahoo dot com

Thank you sir!