International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Tire Kickin' > General FSJ Tech

Thread Tools Search this Thread Display Modes
Old 04-16-2006, 12:53 PM
scoutjeep360 scoutjeep360 is offline
New Member
Join Date: Oct 10, 2005
Location: Gainesville, Tx
Posts: 5

Long story short, lost the original kd linkage and replaced it with a Lokar cable. Does anyone know the proper adjustment for this set up? 727 tranny 304 with a Motorcraft 2 barrel. I have it adjusted now so that the lever on the tranny has no "slack" in it at idle but it will not up shift at any rpm. Yes I searched and only found info on stock linkage. Thanks.
Reply With Quote
Old 04-16-2006, 02:50 PM
Mr. Goatman's Avatar
Mr. Goatman Mr. Goatman is offline
Gear Head
Join Date: Jan 05, 2006
Location: Alamogordo, NM
Posts: 589

When I setup mine(on an edelbrock)I adjusted it to fully pull the cable at WOT. Seems to be about right
Remember; When it comes to tools and toys forgiveness is ALWAYS easier than permission!
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -6. The time now is 11:44 AM.

Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
corner corner