GW rear window deflector mounting

[WHSII]

Hello all,

I need measurements to mount the rear window deflector on a late model Grand Wagoneer.

If I knew the distance from the outer window stainless trim, or from the painted surface, to the first bolt in the center, I would be in good shape.

I also would like to find a piece of wood grain for the deflector. Any leads would be appreciated.

Thanks,
WH

[Carnuck]

I have a deflector but don't know either (don't have a GW anymore)

[men in black]

[WHSII]

Thanks MIB,

That was what I was looking for.

My TSM did not have any reference to the deflector.

Thanks again Sir!

WH

[jsinajeep]

WH, I would of sent these if I new you needed them
And you can get new Well-Nut at your ACE Hardware.
And I can get picture of the Well-Nut if you need it.

[WHSII]

WH, I would of sent these if I new you needed them
And you can get new Well-Nut at your ACE Hardware.
And I can get picture of the Well-Nut if you need it.

Thanks J.

Yes that is what I need, I thought I would have had the cut sheet MIB sent in my TSM, but it was not in there. I have replaced the well nuts in the roof rack, I am sure they are the same.

Thanks Sir, you have been a big help with the parts and info!

WH

[61Hawk]

When I bought mine I just taped it in position until I found where I wanted it then marked the holes.

[jsinajeep]

When I bought mine I just taped it in position until I found where I wanted it then marked the holes.

That is a good way, but this is easier.

[Crist Clapper]

Are you trying to match a woodgrain? If so... Which one?

[WHSII]

Hello Crist,

I was hoping you would reply.

I have the original wood grain, 1987.

I know the piece for the deflector will not match exactly, but being as far as it is from the rest of the other vinyl, I was just hoping for it to be close. Any suggestions?

[Crist Clapper]

I know of these folks: http://www.autotrimdesign.net/Rear_S...d_Wagoneer.asp

Hello Crist,

I was hoping you would reply.

I have the original wood grain, 1987.

I know the piece for the deflector will not match exactly, but being as far as it is from the rest of the other vinyl, I was just hoping for it to be close. Any suggestions?

[WHSII]

Thanks Crist!

[stonehengeheels]

Anybody ever use their stuff?

[Crist Clapper]

I have. The fit is great. It would be difficult to match any woodgrain exactly unless you purchase the same from these folks.

Anybody ever use their stuff?