No offense to the Carolina FSJ Forum, but I thought I might get some more feedback over here first...
Thinking about rebuilding a donor 360 over the next 6+ months, while I still have a pretty decent but underpowered engine in the GW. I also figure I can spread out the need for funds this way, so the wife doesn't have an idea of the total cost...
Anyone in the Southeast NC or Northeast SC areas know about where I can get reputable machining done without breaking the bank?
Thinking about rebuilding a donor 360 over the next 6+ months, while I still have a pretty decent but underpowered engine in the GW. I also figure I can spread out the need for funds this way, so the wife doesn't have an idea of the total cost...
Anyone in the Southeast NC or Northeast SC areas know about where I can get reputable machining done without breaking the bank?
Comment