Ok guys, here's one for you. I hear all the time about this rare adapter (eight bolts) for the turbo 400's. I wanted a dana 20 transfer case to swap in where my exisiting q-trac sits. So I bought one with this adapter. Now here I am with the q-trac pulled (4 bolts) and i'm looking at the two transfer cases, and the dana 20 looks to have the same bolt pattern without the adapter (4-bolts). It appears that the q-trac used the same adapter...and that is still bolted to the back of the tranny. I'm confused.
The adapter will obviously not fit to the back of the tranny as it sits. Do I pull the adapter off the dana 20 and bolt it up, or do I pull the back off the th400 and bolt the dana 20 w/adapter to the back of the tranny? The shaft coming out the back of the tranny is held in by a large bearing, and appears to be part of the tranny. There is a piece of plywood bolted over the adapter on the dana 20, so I have not inspected what's in there...I just figured that it was a shell...kind of like a bellhousing. Can anyone give me some guidance please?
The adapter will obviously not fit to the back of the tranny as it sits. Do I pull the adapter off the dana 20 and bolt it up, or do I pull the back off the th400 and bolt the dana 20 w/adapter to the back of the tranny? The shaft coming out the back of the tranny is held in by a large bearing, and appears to be part of the tranny. There is a piece of plywood bolted over the adapter on the dana 20, so I have not inspected what's in there...I just figured that it was a shell...kind of like a bellhousing. Can anyone give me some guidance please?
Comment