Brougham vynil wood trim

[Adams77]

Anyone know where to get the wood grain vinyl for the thin style molding? I can only find the limited.

[deckside]

Anyone know where to get the wood grain vinyl for the thin style molding? I can only find the limited.

Pretty impossible to find NOS. If the crome outer is still good on your trim you can cut vynal strips for it from what they sell for the Grand and lay them in beteewn the faux chrome out ridges. Im pretty sure the trim option on the Limited is exactly the same for the Broughham. If you need any actual trim pieces and not just the vinyl I may have a few left over after my project. See this thread:

http://www.ifsja.org/forums/vb/showthread.php?t=149052

[deckside]

Just took a look at your rig on the other thread.....not the trim I was expecting. I think I may have the vinyl you are looking (picked up accidentally on EBAY) for however if you can post up a close up picture of your trim.

[Adams77]

[FSJunkie]

3M shelf paper.

[Rdomeck]

3mDenoc

I used 3M DeNoc from http://www.metrorestyling.com It took a little bit to measure out and cut down. I think I had about $200 in the roll. It did provide enough to go down the sides and redo the tops of all four doors on the interior and the small strips on the roof rack. I think I have about 4' left on the roll that I plan to use on my console.

[KaiserMan]

Nice Wag. Just to toss is out there, it's a Custom, not a Brougham.

[deckside]

Nice Wag. Just to toss is out there, it's a Custom, not a Brougham.

I think he got in over his head and sold it

[Adams77]

Nice Wag. Just to toss is out there, it's a Custom, not a Brougham.

Thats funny because it had brougham badges

I think he got in over his head and sold it

I am only 5'8" but not much goes over my head (except reading comprehension). Someone offered more than it was worth to me so I took it.