so i've got a howell tbi i just bolted on and almost have it all hooked up.i have a wire that is suppost to go to the starter sil. but it doesnt say where or what side.anyone know? i was thinking it went on the sarter side but want to be sure before i hook up.thanks
howell TBI help
Collapse
X
-
I dont know about the howell, but I think its based off the GM TBI systems correct? If so that is probably the starter signal wire. Whereever you hook it to the starter solenoid, make sure its only getting power when the starter motor is enguaged. The ECM gets a signal from that wire letting it know you are trying to start the engine.79 Cherokee Chief 401/T18/D20, MPFI fuel injection, hydroboost, otherwise stock.
Future mods: Caddy 500/NV4500/NP205, HP D60 front D60 smooth botom rear, 5.13 gears, 35x12.50's on H1 beadlock wheels. Warn M12000 winch.
93 Wrangler 4.6 stroker/AX15/NP231,SYE,CV, OME 2.5 lift, front hub conversion/big brakes, 31X10.50's Warn M10000 winch.
-
-
I agree ^ I believe that is the crank signal. Needs to know when the enging is cranking so the fuel can be adjusted accordingly. Might retard the timing also, IDK.1986 CJ7, AMC 304/ T-176
1968 Scout 800, 152/T-18
1971 Scout 800B, 345/727
CJ10-A Tug,Waggy axles, Sd33, 727
Comment
-
-
thats what i was thinking but the directions didn't say.thanksStupidity is often rewarded with pain.
86 waggy fresh 360 big bore tbi and all the works fresh727/208 4:27s front locked rear spooled 4'' bjs springs and 2'' body 37s irok(as of now) lots of cuttin.
Comment
-
Comment