If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thought I'd test fit the new console. This lets me have rear air, cupholders front and back, power devices and a place to put the heated seat controls.
I thought I'd cover the armrest pad and lower section of the sides with a marine grade vinyl I found that really almost matches the leather. Paint the top portion either burgundy or black, and laminate a cover (to fill the space just under the original dash A/C vents) with a woodgrain that closely matches the interior woodgrain. And try to throw in some nice chrome trim.
Recovered the steering wheel last night using a wheelskin replacement. I went over the existing cover instead of removing. I like them a little cushioner and thicker. The downside is that there's a little more of a gap on the threaded part, but not a big deal if you move that side more to the opposite side of the wheel so you don't really notice it.
Comment