does anyone have the measurements for a 1977 era dana 44 open knuckle? Looking for the dimension betweent bottom edge of ball joint surface and the top of top ball joint surface.
Mine may be bent but don't have another set to compare. After replacing the ball joints (Moog) i cant tighten upper balljoint seat down to 50lbs of torque - it almost drops out through the bottom before getting even close to tight. Thinking the knuckle may be bent.
Any other advice would be great!
Mine may be bent but don't have another set to compare. After replacing the ball joints (Moog) i cant tighten upper balljoint seat down to 50lbs of torque - it almost drops out through the bottom before getting even close to tight. Thinking the knuckle may be bent.
Any other advice would be great!
Comment