Thread: Rear Glass
View Single Post
  #9  
Old 09-02-2000, 09:32 AM
Ralph's Avatar
Ralph Ralph is offline
Third Member
 
Join Date: Apr 11, 2000
Location: Telluruide, CO
Posts: 3,548
Wink

They have a retainer clip at each regulator arm intended to hold the pin in the channel slot. Also, that pin should turn freely, or else one side of it will get worn flat.

The pins are machined in place. I removed both of mine and replaced them with my own mix of nuts, bolts, springs, and finishing washers. About two months now and it seems to be holding up fine.
Reply With Quote