If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
80 Cherokee
360 ci 727 with
Comp cams 270 h
NP208
Edlebrock performer intake
Holley 4180
Msd total multi spark.
4" rusty's springs
Member, FSJ Prissy Restoration Association
If you can't make it better why waste your time. No use repeating the orignal mistakes. I'm to old to push it that's why.
does anybody have any suggestions as to how to get the window up?...I live in a pretty bad neighborhood...
1980 Jeep J-20
1979 Jeep J-10 Honcho
1991 Jeep Grand Wagoneer
1975 Jeep Wagoneer- The Green Bastard, from Parts
Unknown
1968 Plymouth Satellite
1978 Camaro- back in action
1980 'Vette. Chevette. Please someone buy this
does anybody have any suggestions as to how to get the window up?...I live in a pretty bad neighborhood...
Hook a battery up to the motor wires by removing the inspection plate & pulling the wires off the switch put them on the battey one way it goes down the other it goes up.
80 Cherokee
360 ci 727 with
Comp cams 270 h
NP208
Edlebrock performer intake
Holley 4180
Msd total multi spark.
4" rusty's springs
Member, FSJ Prissy Restoration Association
If you can't make it better why waste your time. No use repeating the orignal mistakes. I'm to old to push it that's why.
Provided the wiring to the motor is still intact?
And the safety switch is closed? (you checked it like suggested above?)
...you can unplug the harness coming out of the tailgate under the truck and apply power to the tailgate motor wiring and raise/lower the window depending on polarity.
Done it several times in the boneyard to grab parts vs. the hard way.
There's no safety switch if you connect the battery to the motor. LOL if the safety switch or the tailgate switch is junk feeding from the plug inderneath is useless. If the front switch is bad or there is a power problem then the plug might work.
zero odds zero guess work hook the MOTOR wires up to a battery.
80 Cherokee
360 ci 727 with
Comp cams 270 h
NP208
Edlebrock performer intake
Holley 4180
Msd total multi spark.
4" rusty's springs
Member, FSJ Prissy Restoration Association
If you can't make it better why waste your time. No use repeating the orignal mistakes. I'm to old to push it that's why.
Hook a battery up to the motor wires by removing the inspection plate & pulling the wires off the switch put them on the battey one way it goes down the other it goes up.
I Had It Open But Couldn't Get To Anything Because The Glass Is In The Way. Can I Reach Anything From The Hinge Covers? I Didn't Open Those.
I Backed It Into My Driveway Hoping That Will Deter Thieves While I Pick Up My Daughter From School.
1980 Jeep J-20
1979 Jeep J-10 Honcho
1991 Jeep Grand Wagoneer
1975 Jeep Wagoneer- The Green Bastard, from Parts
Unknown
1968 Plymouth Satellite
1978 Camaro- back in action
1980 'Vette. Chevette. Please someone buy this
Provided the wiring to the motor is still intact?
And the safety switch is closed? (you checked it like suggested above?)
...you can unplug the harness coming out of the tailgate under the truck and apply power to the tailgate motor wiring and raise/lower the window depending on polarity.
Done it several times in the boneyard to grab parts vs. the hard way.
I Have Been Checking The Switch Every Time I Tried It. Do You Happen To Know What Color The Wire Is?
1980 Jeep J-20
1979 Jeep J-10 Honcho
1991 Jeep Grand Wagoneer
1975 Jeep Wagoneer- The Green Bastard, from Parts
Unknown
1968 Plymouth Satellite
1978 Camaro- back in action
1980 'Vette. Chevette. Please someone buy this
You can try it from the plug underneath but as I stated if there is a problem with the safety switch or the tailgate switch it still won't work. Nobody said anyone said they were or weren't.
I'm not saying the plug won't work I'm saying if it is one of the tailgate switches it won't. I've been there. If the tailgate switch fails there's only one way to get to it. well you could smash the glass.
Also you can remove the clips off the glass & push it up wedge it in or hook some wires up to the motor re-connect the window then roll it up.
To the point if the motor isn't intact then all this is a Moot.
80 Cherokee
360 ci 727 with
Comp cams 270 h
NP208
Edlebrock performer intake
Holley 4180
Msd total multi spark.
4" rusty's springs
Member, FSJ Prissy Restoration Association
If you can't make it better why waste your time. No use repeating the orignal mistakes. I'm to old to push it that's why.
1980 Jeep J-20
1979 Jeep J-10 Honcho
1991 Jeep Grand Wagoneer
1975 Jeep Wagoneer- The Green Bastard, from Parts
Unknown
1968 Plymouth Satellite
1978 Camaro- back in action
1980 'Vette. Chevette. Please someone buy this
If there's is it's the ones I pointed out in like #3
Bottom left corner of the diagram the safety switch but as stated a million times if the safety switch is bad that is the magic bullet. Notice the 2 wires going to the switch one goes via the switch to the motor. Jump those 2 if you lucky only from inside the tailgate. BTW Mine were white. ONLY if the safety switch is bad other than that the Motor wires & connecting a battery to them. there's not a lot of options & whoever designed the system had no thought of a user servicable system. I know there's no good news but I've messed with these things a lot that is why I redesigned mine.
80 Cherokee
360 ci 727 with
Comp cams 270 h
NP208
Edlebrock performer intake
Holley 4180
Msd total multi spark.
4" rusty's springs
Member, FSJ Prissy Restoration Association
If you can't make it better why waste your time. No use repeating the orignal mistakes. I'm to old to push it that's why.
Yes, If your tailgate key switch is centered and your safety switch is made or jumpered.
In the center of page 41 there are two plugs, one (left rear engine compartment at dash,
The other under center of rear body) Unplug before applying 12 volts.
You can use these to made the window go up or down. just contact 12 volt to these wires.
Last edited by men in black; 03-22-2013, 07:47 AM.
1990 Grand Wagoneer.. black with sand interior.. Razor grille, Hella H4 headlights, Piaa driving, LED spider taillights, tinted windows. Full Corinthian leather front and rear seats, custom full length center console with cup holders. 100 sf of Rattle Trap on floor. Edelbrock intake and 2132 cam, Howell TBI, Ford Distributor Cap, TFI Ignition Coil, Desmogged
Comment