View Single Post
Old 11-05-2011, 12:22 AM
babywag's Avatar
babywag babywag is offline
out of order
Join Date: Jun 08, 2005
Location: Land of froot loops and cukcoo-nuts, CA
Posts: 9,559
The DA errors keep popping up on the bottom status block for ALDL connection.
Where it says DA: Not Connected/Connected
Don't know if it's my crappy laptop, homemade cable, or ?
Found a lot of references online to people with a similar/same issue with v5 of tunerpro.
Doesn't seem to effect anything just bugs me.

Rained today, so worked on the memcal.
Unsoldered and removed the stock chip, read the bin, made a few changes, burned a new chip, and soldered it to the memcal.
(Wanted to keep the esc module/limp mode resistor packs)
Ordered a Moates header, so I'll be able to burn different bins to it.

Holy cow there is a lot in there vs. the old 7747 ecm!
Reply With Quote