View Single Post
  #1  
Old 08-21-2018, 11:58 AM
rang-a-stang's Avatar
rang-a-stang rang-a-stang is offline
360 AMC
 
Join Date: Oct 31, 2016
Location: Camarillo, CA
Posts: 2,826
How would you prep this metal? Is there supposed to be a rubber plug here?

Getting my firewall prepped for paint. Last night I removed the wiper motor, column, and booster. Tonight I hope to remove the heater box and blower motor. My plan is to hit it with my electric dual action sander with some 150'ish grit to get it down to bare metal. I plan to paint from the body seam lined in red here, down to the floor pans, out to the door jams on either side.


My questions:
a) The green arrow on this picture shows a body hole. I assume this should have a rubber body plug in it, right? (same on the other side). I am not sure why they were be missing but they are.
b) Do you think I am OK just sanding this light surface rust off and hitting it with self etching primer, then base/clearing over it? I am not real worried about finish here since it's hidden behind the fender but I don't want it to rust, either.
__________________
79 Cherokee Chief, barely runs
(Cherokee Build Thread)
11 Nissan Pathfinder Silver Edition 4x4
09 Mazdaspeed3 Grand Touring
Reply With Quote