This is what I wrote on page 48, post, 958. Good luck.
Thanks Al! Wanted to let you know, I tried to install them like you did with the bottom gasket out. I could not make it work, it was to tight with the new gaskets. (I think you reused the old gaskets on Saide) I put it back together and pushed the lower gasket past the inner and outer door skins. Then once the top of the glass is past the upper door channel, you can push the lower gasket back up where it belongs. Pretty much like the TSM says to do. You talk about a handful trying to handle a wet and soapy piece of glass. Thanks again, Darin.
401/turbo 400 trans. Quadra-Trac BW1339 (with Low) 4" Rusty's lift with 31" Summit Mud Dawgs
Fuel Tank, Red Holley Fuel Pump, Razor Grill (profile pic out dated), Rebuilt steering box