View Single Post
Old 12-03-2008, 01:43 PM
dusty's Avatar
dusty dusty is offline
Gear Head
Join Date: Jul 20, 2006
Location: Left Coast, Right wing. Nor Cal
Posts: 744
Originally Posted by JeepinPete
What are your plans for the air intake? With the way the plastic pipe is looping back, it looks like you are setting up for a snorkel.

using the sewer pipe as mock up, it is 4" OD so i could check clearance under the 2-1/2" pressurized tube going over it. i plan on getting some 4" ducting compressing it some and then routing it in that spot.

i am planning to put the air filter up on the fender right in front of the heater core and blower motor

like i noted backa page or tewo the objective is to get an efficient running and responsive (fairly clean at the tail pipe) 180-185hp / 425-430 ft/lbs if i can get it to 200/460 or 205/475 that would be better than expected
Cherokee S Chief Widetrack W/ Cummins 4bta Diesel, 91 dodge intercooler, hy35/9, AC NV4500/D300 3.54's Ploks 4" BJ's w/ 33's, scout 33 gal fuel tank ( Sold, to a good fsj home)
The 608.9 hybrid dana 44 build

AMC 401 supporter

GO UM Montana Griz

"Dont worry the Coors light engineering department will be documenting this accordingly."

Last edited by dusty : 12-03-2008 at 03:44 PM.
Reply With Quote