Thread: T-18 question
View Single Post
  #12  
Old 02-17-2020, 08:00 AM
rocklaurence rocklaurence is offline
Moderator
 
Join Date: Jan 14, 2009
Location: 33812, Lakeland, Fl
Posts: 1,734
First, the input needs to be pulled backwards to remove it from the case. If your going to replace the front bearing without total disassembly, you only need to be concerned about Not letting the needle bearings fall out during the process. If you can do it without lifting the input, your OK. Second, there should be a fill plug approx' in the middle of the case and a drain plug at the bottom.
Reply With Quote