Help with Q-trac

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • StuS77J20
    232 I6
    • May 06, 2014
    • 39
    #1

    Help with Q-trac

    I am working on rebuilding my t-case and the low reduction unit came apart after I took it off. Not a problem except that the is a spacer ring that should be next to the sun gear. The ring is open about 3/8's of an inch (broken?) and is now inside the sun gear. Don't know how this happened, but I don't think it should be there. Does anyone haven't any suggestions? Any help is hugely appreciated.
    If you're not where you're at you're nowhere!
    '77 J20, 401, TH400/QT, D60/3.73FF, D44HD/3.73, 8600GVWR, 131" WB
    Tags: None
  • wiley-moeracing
    350 Buick
    • Feb 15, 2010
    • 1430
    #2
    picture please ? then I can help

    Comment

    • StuS77J20
      232 I6
      • May 06, 2014
      • 39
      #3
      will post as soon as I can get pics.
      If you're not where you're at you're nowhere!
      '77 J20, 401, TH400/QT, D60/3.73FF, D44HD/3.73, 8600GVWR, 131" WB

      Comment

      • StuS77J20
        232 I6
        • May 06, 2014
        • 39
        #4
        Here's the pics. If I am doing something wrong in sending them let me know.

        http://i288.photobucket.com/albums/ll163/SBell6072/2015-06-13%2014.03.42_zpsnkkpeg1f.jpg


        Have you ever had the low range unit apart before? Apparently the snap ring goes onto the main shaft. Still don't know if it's supposed to be inside the sun gear. Anyway, you should be able to look at the picture and see where the snap ring is and the splines are. Any knowledge you can give me is greatly appreciated!
        If you're not where you're at you're nowhere!
        '77 J20, 401, TH400/QT, D60/3.73FF, D44HD/3.73, 8600GVWR, 131" WB

        Comment

        Previous template Next
        Working...
        X