ok can anyone out there tell me if there is a diagram for the connectoers under the dash? I'VE HAD THE STEERING COLOM OUT AND HAD ALOT OF THE PLUGS DISCONNECTED ... nothings happening when i turn the key... there are a few plugs un hooked but i cant find where they go.. grrr
NOTHINGS HAPPENING!!!
Collapse
X
-
remember to hook up the negative on the battery? just throwin that out there...ROMANS 12:1-2
Military guys- Check out www.MilitaryJeepers.com
'89 GW deceased
Ford 4spd swap Np435/205
Lifted/stretched on 36's/4.10 thick gears/spooled rear
'86 CJ-7 Renegade, Restored, original steel.
new Built TBI 258/Np435/D300 twin-sticks/Waggy D44's
37" Super Swampers and lots of goodies!
-
-
Only said it because I've done it before...more than once.ROMANS 12:1-2
Military guys- Check out www.MilitaryJeepers.com
'89 GW deceased
Ford 4spd swap Np435/205
Lifted/stretched on 36's/4.10 thick gears/spooled rear
'86 CJ-7 Renegade, Restored, original steel.
new Built TBI 258/Np435/D300 twin-sticks/Waggy D44's
37" Super Swampers and lots of goodies!
Comment
-
-
I don't think it is abnormal to have a few connections hanging not hooked up. Or atleast it isn't for a J truck. none of mine have all the options a waggy has and I have connectors hanging loose going nowhere but the truck runs fine.
I think the only way to track this down would be to check each component in the system until fire is made. Did you by any chance knock the connection loose down low where the neutral safety switch is?
Do all your lights work?
A Technical Service Manual for the 91 year is your best friend for Jeep info. It will have the wiring diagrams also.Tom Gibson
1980 J20 Utility bed truck. Factory cab and chassis truck. Many new mods for it but it will look all stock.
1985 J10 nothing special just a nice clean stock truck.
1977 Honcho "Blue" 401/400/quad. Under going major upgrades.."This is Not Your Fathers Honcho", it may not even be a Honcho anymore when done.
2017 Challenger. Very jealous of the Jeeps.
Comment
-
-
Here's the ignition wiring diagram for a 90, should be quite similar for 91. http://oljeep.com/gw/elec/90_numeric...-8W_Page-6.jpg1991 GW 4bbl Edelbrock intake, carb & MSD ignition (wrecked)1988 GW bone stock (donor)(Under Recovery)
Drive safe Drive a FSJ!
Henning Kjensli
Comment
-
-
Well, fi everything is working, except items that are energized by the key, I would take a close look at your column install, specifically ensuring that the connectors are properly locked together, etc. I would also have a look at the linkage which connects the key cylinder to the actual switch. Chances are, that your problems are going to be related to the actual work you did(removing and replacing column).67 M715
Cummins 4BT/Allison 54/Ford203/Ford205,
Front 89 HP60/Rear 81 GM D70HD
Discs all around/ 12 bolt H1 Rims
Build still very much in progress
78 Levi edition Honcho 360/T18/D20
Comment
-
Comment