coil conversion

[Rayzor]

any body done this
i want to go from leafs to coils
wat coils etc..
is this worth while
is there another vehicle i can use parts from
as of right now shes lifted 6in and thats as high as shes going
thanks in advance

[243]

I did it this past weekend, the Motorcraft ignition module on my 78 was puking good down the fenderwell so I upgraded to a big cap, Ford TFI coil, new wires and swapped the MC module for a GM module. Took a few hours, easy and runs great.

I think the coil and wires are from an 89 Ford pickup without EEC.

[Rayzor]

want to get rid of leaf springs and go to coil springs

[243]

TFF, I didn't even read between the lines, I didn't read at all

[crazydog]

There was a thread on here a few years ago that detailed the installation of basically the front suspension of a Bronco. It had tons of pictures (which are probably gone) and lots of detail. I think he used some Duff?? parts to get around a 6" lift.

[blazer3664]

check out cu4whln's build.
JK suspension I believe, with Rubicon axles.

The suspension starts here.............

http://www.ifsja.org/forums/vb/showthread.php?t=89280&page=17

Jim