I've got a small electric heater I can use if I really need to, but I don't want to run up the electric bill to much.
I got the tranny mounted today. I just had to drill one hole in the metal tranny mount, two for the TH400 mount in the top of the civi x-member and on in the side for the M715 torque stud.
I also had to make a new mount for the torque stud, as the stock piece of angle wasn't long enough for me to mount it to the side of the x-member.
I have to slot the hole in the x-member for that bracket, as I managed to get the tranny mount bracket 3/16" higher on that side. It's also offset to the driver side 1/8".
Pretty close I think.
I got the tranny mounted today. I just had to drill one hole in the metal tranny mount, two for the TH400 mount in the top of the civi x-member and on in the side for the M715 torque stud.
I also had to make a new mount for the torque stud, as the stock piece of angle wasn't long enough for me to mount it to the side of the x-member.
I have to slot the hole in the x-member for that bracket, as I managed to get the tranny mount bracket 3/16" higher on that side. It's also offset to the driver side 1/8".
Pretty close I think.
Comment