International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 112
Search took 0.04 seconds.
Search: Posts Made By: redwoody
Forum: General FSJ Tech 06-05-2020, 03:54 PM
Replies: 12
Views: 512
Posted By redwoody
Im thinking the carb is not tight. I got 2 in of...

Im thinking the carb is not tight. I got 2 in of vac replacing power valve. But that all feels like another life. :confused:
Forum: General FSJ Tech 06-03-2020, 07:48 PM
Replies: 12
Views: 512
Posted By redwoody
replaced balancer w/oreilly warranty. Its 48*...

replaced balancer w/oreilly warranty. Its 48* off. Physically bring #1 tdc and balancer is on mark. I have a much bigger issue. Young guy made a left in front of me. I think its totalled. Had her...
Forum: General FSJ Tech 05-25-2020, 06:30 PM
Replies: 12
Views: 512
Posted By redwoody
All 8 cyl are 125 - 135psi.

All 8 cyl are 125 - 135psi.
Forum: General FSJ Tech 05-19-2020, 07:30 PM
Replies: 12
Views: 512
Posted By redwoody
Borrowed a timing light shows the same thing. So...

Borrowed a timing light shows the same thing. So my dampner must have moved. Also found leaking power valve.
Forum: General FSJ Tech 05-18-2020, 04:21 PM
Replies: 12
Views: 512
Posted By redwoody
I was thinking if damper moved that much the...

I was thinking if damper moved that much the rubber would be pretty distorted and would have vibration. Just changed carb gskt and i noticed 2 in of hg better but still shaky. Next morn had it warmed...
Forum: General FSJ Tech 05-17-2020, 07:22 PM
Replies: 12
Views: 512
Posted By redwoody
vac and timing

Long story short the vac at warm idle and vac can unhooked is around 14-15 and unsteady. i have all vacuum lines pluged even vac ball at back of engine that controls heat and a/c doors. Unhooked pwr...
Forum: General FSJ Tech 05-17-2020, 04:57 PM
Replies: 2
Views: 204
Posted By redwoody
thx i will look into that. Although it leaks at...

thx i will look into that. Although it leaks at the plate where propeller gears run against.
Forum: General FSJ Discussion 05-16-2020, 03:58 PM
Replies: 4
Views: 291
Posted By redwoody
Oh yes put a water hose to the door came in like...

Oh yes put a water hose to the door came in like door was open. Put hose across glass and cowl. All water was around door.
Forum: General FSJ Discussion 05-16-2020, 01:14 PM
Replies: 4
Views: 291
Posted By redwoody
Door seals

what is the remedy? My door seals are still like new and i adj the doors tighter still leaks. I was thinking to slide a drinking straw inside of seal. thx
Forum: General FSJ Tech 05-16-2020, 12:57 PM
Replies: 2
Views: 204
Posted By redwoody
Oil pump tolerance

7000 on rebuilt 360. oil pump leaked w/ in first 1000 miles. I have front engine seal felpro kit which is the gskt it has on it. Do all have better gasket or way to seal.
Forum: General FSJ Tech 05-05-2020, 08:01 PM
Replies: 11
Views: 1,328
Posted By redwoody
revolution electronics has a module that gives a...

revolution electronics has a module that gives a 3 sec prime plus reads off ur tach signal to stop fuel pump
Forum: General FSJ Tech 05-05-2020, 07:03 PM
Replies: 9
Views: 281
Posted By redwoody
fixed

In last rebuild of carb i did not attach needle seat to float. Fuel pressure had to lift the needle. thx
Forum: General FSJ Tech 05-03-2020, 02:09 PM
Replies: 9
Views: 281
Posted By redwoody
new sock in tank and new filter b4 elec pump. ...

new sock in tank and new filter b4 elec pump. mechanical has been blocked. will change filter by carb and ck float level thx. About 1/2cup of fuel in 5 sec at carb.
Forum: General FSJ Tech 05-03-2020, 01:30 PM
Replies: 9
Views: 281
Posted By redwoody
I let up to stop it from bogging and...

I let up to stop it from bogging and reaccelerating is smooth. If accel hard then loss of fuel again.
Forum: General FSJ Tech 05-03-2020, 12:46 PM
Replies: 9
Views: 281
Posted By redwoody
Air cleaner is blocked open. It started...

Air cleaner is blocked open. It started happening few months after rebuild. I did a quick clean rebuilt on carb. Didnt change any adjustments. I changed out the accel pump yesterday, maybe a little...
Forum: General FSJ Tech 05-02-2020, 10:41 PM
Replies: 9
Views: 281
Posted By redwoody
out of fuel at high rpm

rebuilt stock 360 rv cam and 2150 2v. New precision electric pump from oreillys 30gph 4psi bogs at higher rpm. Had mr gasket pump 12s very little change. thx
Forum: General FSJ Tech 02-08-2020, 10:09 PM
Replies: 33
Views: 3,050
Posted By redwoody
pics

Sorry Im not able to see these pics. any help thx
Forum: General FSJ Tech 08-15-2019, 05:12 PM
Replies: 11
Views: 561
Posted By redwoody
temp switch for egr may allow vac to bypass. Test...

temp switch for egr may allow vac to bypass. Test by unhooking vac to egr
Forum: General FSJ Tech 08-08-2019, 04:54 PM
Replies: 7
Views: 671
Posted By redwoody
Took wag to builder. He replaced my pcv (was...

Took wag to builder. He replaced my pcv (was intermittent) w/ Dodge 360 set up. Don't need formed hose to base of carb. also my trap door in air cleaner(vac motor) was not opening fully. Hope this...
Forum: General FSJ Tech 07-01-2019, 07:56 PM
Replies: 7
Views: 671
Posted By redwoody
my charcoal can is all plugged off. Vac lines...

my charcoal can is all plugged off. Vac lines have been removed. Theres no response using carb cleaner at base of carb. I just purchased the gskt under spacer for 2150. Pcv is clean and moves. Thx
Forum: General FSJ Tech 06-30-2019, 02:23 PM
Replies: 6
Views: 561
Posted By redwoody
vapor locking. Put electric pump near tank and...

vapor locking. Put electric pump near tank and have no issue since. make sure u have filter with two lines going to carb and other return to tank
Forum: General FSJ Tech 06-30-2019, 02:03 PM
Replies: 7
Views: 671
Posted By redwoody
vacuum ball and under dash Thx. Did ck booster...

vacuum ball and under dash Thx. Did ck booster by removing line and plugging no change on vac guage
Forum: General FSJ Tech 06-29-2019, 08:51 PM
Replies: 7
Views: 671
Posted By redwoody
vac leak

fresh 360. I have vac pump and cheked all vac lines. New EGR. Used full can of gum out around intake and base of carb. Checked line to vacuum booster. My transfer vacuum operates 4x4. adv vac holds....
Forum: General FSJ Tech 05-19-2019, 04:59 PM
Replies: 5
Views: 368
Posted By redwoody
does ur 727 convertor come with ring gear or an...

does ur 727 convertor come with ring gear or an actual flywheel? My jeep convertor came w/ no ring gear no weights and 10 in bolt pattern
Forum: General FSJ Tech 05-09-2019, 07:32 PM
Replies: 8
Views: 565
Posted By redwoody
Found vacuum leak was base of carburetor did not...

Found vacuum leak was base of carburetor did not have proper gskt. Always check simple first::banghead: The simple moved into complicated area as I had to shave the mounting posts of plastic...
Showing results 1 to 25 of 112

 
Forum Jump

All times are GMT -6. The time now is 07:43 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
corner corner