International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 3.50 seconds.
Search: Posts Made By: fulsizjeep
Forum: General FSJ Tech 02-01-2018, 09:46 AM
Replies: 14
Views: 277
Posted By fulsizjeep
Some QT info over here, including...

Some QT info over here, including TSM:
http://jubileejeeps.org/quadratrac

I think I would first drop the front drive shaft and inspect all the ujoints. If the double joint gets worn enough, it can...
Forum: General FSJ Tech 01-10-2018, 12:31 PM
Replies: 3
Views: 178
Posted By fulsizjeep
It is orange. There is a yellow one that follows...

It is orange. There is a yellow one that follows the same path to the kickdown switch on the tranny. You can see them on this diagram...

http://oljeep.com/gw/elec/78/78_FSJ_WiringDiagramPage7.jpg
Forum: General Chit-Chat 12-06-2017, 06:49 AM
Replies: 16
Views: 498
Posted By fulsizjeep
He's a good guy. When Mike was getting out of...

He's a good guy. When Mike was getting out of FSJs, I picked up his spare rebuilt 208 for my 88.

I met Doc and Timex once when I lived in FL. Wanna say 98 or 99? The bottomless transfer case!

I...
Forum: FSJ-PRIS 11-09-2017, 03:13 PM
Replies: 32
Views: 2,475
Posted By fulsizjeep
:thumbsup: Well done SIR! :thumbsup: It is...

:thumbsup: Well done SIR! :thumbsup:
It is beautimous!
Forum: General FSJ Tech 11-09-2017, 11:59 AM
Replies: 13
Views: 454
Posted By fulsizjeep
For the sake of clarity, these are actually...

For the sake of clarity, these are actually called Brake Cones. The cone washers are another area of fail that has no new parts replacements available. It usually takes me going through a few to...
Forum: General FSJ Tech 10-30-2017, 02:14 PM
Replies: 10
Views: 457
Posted By fulsizjeep
A 2" lift will fit 31x10.5x15s but there...

A 2" lift will fit 31x10.5x15s but there could be some rub in the front of the rear fender wells at full stuff. To really clear 31s with no rear rub takes 4" lift or you can roll the lip in on the...
Forum: General FSJ Discussion 10-27-2017, 11:56 AM
Replies: 13
Views: 586
Posted By fulsizjeep
Been running HEI here for a while. It was the...

Been running HEI here for a while. It was the best solution in my mind for the Prestolite fails. The first Mallory ran from 2010 to 2013 when it just started eating modules like candy. We were...
Forum: Street & Performance 10-13-2017, 03:52 PM
Replies: 16
Views: 1,436
Posted By fulsizjeep
Random thoughts: I use 800-1200 rpm stall...

Random thoughts:
I use 800-1200 rpm stall converter. 3000 or 1800 is nutz for an FSJ. I am not drag racing them. Why are we talking about Chevys? Just my $.02.
Forum: General FSJ Tech 10-12-2017, 12:45 PM
Replies: 37
Views: 1,961
Posted By fulsizjeep
I make my own gasket out of 1/16" thick...

I make my own gasket out of 1/16" thick gasket paper. I don't think I would double up the standard gasket. If you have a leak between the T400 adapter and the QT, it has to be the paper gasket or...
Forum: General FSJ Tech 10-12-2017, 10:47 AM
Replies: 6
Views: 355
Posted By fulsizjeep
:thumbsup: Section 8 has the transfer...

:thumbsup:

Section 8 has the transfer cases.
http://oljeep.com/gw/76_tsm/Section8.pdf
Forum: General FSJ Tech 10-06-2017, 04:57 PM
Replies: 33
Views: 985
Posted By fulsizjeep
Looks like you are on the right path. The front...

Looks like you are on the right path. The front drive shaft in the picture is not for the 72. It is specific to 73-79 QuadraTrac FSJs. Good luck.
Forum: General FSJ Tech 10-06-2017, 04:12 PM
Replies: 6
Views: 355
Posted By fulsizjeep
Welcome! Since you have the QT, you probably...

Welcome! Since you have the QT, you probably want to be familiar with this web site:
www.jubileejeeps.org/quadratrac

There is no silver bullet for the QuadraTrac. BJs Offroad has a few parts. ...
Forum: General FSJ Tech 09-15-2017, 01:39 PM
Replies: 37
Views: 1,961
Posted By fulsizjeep
I am all for the Hemi swap :thumbsup: but I...

I am all for the Hemi swap :thumbsup: but I really doubt that thicker gasket had anything to do with the broken ear.

For those that try to install the QT with the front shaft bolted up, Good Luck...
Forum: General Chit-Chat 08-31-2017, 04:57 PM
Replies: 16
Views: 824
Posted By fulsizjeep
:D This one has crossed the rainbow bridge. It...

:D This one has crossed the rainbow bridge. It was worked hard and put up wet most days until 2004. I got my 401 out of it. It had been used in VA to launch and pull boats in and out of salt...
Forum: General FSJ Discussion 08-18-2017, 02:43 PM
Replies: 139
Views: 9,822
Posted By fulsizjeep
Keep it flowing. Been clocking 300-400 miles a...

Keep it flowing. Been clocking 300-400 miles a week since the end of March.
Forum: Build Threads 05-29-2017, 09:18 AM
Replies: 445
Views: 34,048
Posted By fulsizjeep
What a wild ride. I really appreciate your...

What a wild ride. I really appreciate your desire to go MOPAR and Hemi to boot. Good luck on the tcase hunt! :thumbsup:
Forum: Street & Performance 04-16-2017, 11:26 AM
Replies: 398
Views: 76,213
Posted By fulsizjeep
Love that squat and go look on the Cherk! ...

Love that squat and go look on the Cherk! :thumbsup:
Forum: General FSJ Tech 04-16-2017, 11:22 AM
Replies: 20
Views: 1,118
Posted By fulsizjeep
That makes for an easy way to go 3/4 ton. Good...

That makes for an easy way to go 3/4 ton. Good on you! :thumbsup:
Forum: General FSJ Discussion 04-16-2017, 09:53 AM
Replies: 12
Views: 1,177
Posted By fulsizjeep
If you really want to test it, most AutoZones...

If you really want to test it, most AutoZones have a tester that works on the Prestolite and Duraspark ignition modules.
Forum: General FSJ Discussion 04-16-2017, 09:36 AM
Replies: 24
Views: 1,727
Posted By fulsizjeep
THAT is awesome Tony! :thumbsup: New Tunes ...

THAT is awesome Tony! :thumbsup:


New Tunes :)

http://i232.photobucket.com/albums/ee184/jubileejeeps/new%20tunes.jpg
Forum: General FSJ Discussion 04-08-2017, 08:16 AM
Replies: 7
Views: 938
Posted By fulsizjeep
I have found that a fairly common reason for an...

I have found that a fairly common reason for an HEI to start blowing modules is actually in the pickup coil down in the bottom of the dizzy.

Buy two of these and save your self some money on the...
Forum: General FSJ Tech 02-28-2016, 08:07 AM
Replies: 6
Views: 628
Posted By fulsizjeep
I personally think it is silly to put a high...

I personally think it is silly to put a high stall converter in a FSJ unless you are drag racing. I always use stock converter and have not been disappointed.
Forum: General FSJ Tech 02-28-2016, 08:00 AM
Replies: 6
Views: 514
Posted By fulsizjeep
Any easy swap is to change to Dana 20. Just need...

Any easy swap is to change to Dana 20. Just need to find a T400/D20 donor set up.

I find it hard to believe anyone is getting better mileage out of a MM PT kit. We ran one for a few months and did...
Forum: Commercial Vendors: 02-09-2016, 11:57 AM
Replies: 37
Views: 16,661
Posted By fulsizjeep
I am curious what you ordered and what it is for....

I am curious what you ordered and what it is for. I have always liked the look of the end product from Steve.
Forum: General FSJ Discussion 01-03-2016, 09:01 AM
Replies: 2
Views: 626
Posted By fulsizjeep
The Edrive light could be coming on for a few...

The Edrive light could be coming on for a few different reasons, wiring, bad vacuum shifter, bad Edrive indicator switch, vacuum problems with Edrive shifter system, and more... It should only come...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 03:12 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
corner corner