International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 74
Search took 0.01 seconds.
Search: Posts Made By: PBG928
Forum: General FSJ Tech 08-04-2020, 04:34 PM
Replies: 8
Views: 289
Posted By PBG928
Note that all Four Seasons AC evaporators are all...

Note that all Four Seasons AC evaporators are all Aluminum despite pictures showing them to be copper. I ordered one from Team Grand Wagoneer several months ago baed on picture showing copper tubing....
Forum: General FSJ Tech 08-04-2020, 04:22 PM
Replies: 3
Views: 284
Posted By PBG928
If you drop tank from front with rear hoses...

If you drop tank from front with rear hoses attached you can tilt enough to replace them without fully dropping tank. Loosen straps and skid plate next to drive shaft as well.
Forum: General FSJ Tech 05-25-2020, 06:04 AM
Replies: 4
Views: 471
Posted By PBG928
The TGW kit comes with two strips of double stick...

The TGW kit comes with two strips of double stick tape that works good on straight sections. I added a third piece of tape between the two original strips for more holding power. On fenders and...
Forum: General FSJ Tech 04-08-2020, 03:00 PM
Replies: 2
Views: 206
Posted By PBG928
Makes sense. With EFI I obviously do not need it....

Makes sense. With EFI I obviously do not need it. Thanks.
Forum: General FSJ Tech 04-08-2020, 12:37 PM
Replies: 2
Views: 206
Posted By PBG928
Oil pressure light wiring

I replaced motor on my 86 GW and installed new oil pressure light sending unit(two pole) and the larger oil pressure gauge sending unit that has one pole. Oil pressure gauge is now working fine. I...
Forum: General FSJ Discussion 01-24-2020, 04:44 PM
Replies: 4
Views: 431
Posted By PBG928
https://charlotte.craigslist.org/pts/d/charlotte-j...

https://charlotte.craigslist.org/pts/d/charlotte-jeep-grand-wagoneer-rain/7057336142.html
Forum: General FSJ Discussion 01-24-2020, 04:32 PM
Replies: 4
Views: 431
Posted By PBG928
Look up Jonny Cobia on Facebook. He sells...

Look up Jonny Cobia on Facebook. He sells stainless drip rail trim that is the best I have seen. $300 plus shipping.
Forum: General FSJ Discussion 01-20-2020, 08:44 PM
Replies: 8
Views: 676
Posted By PBG928
Not good with pics on here. Camel is almost ...

Not good with pics on here. Camel is almost perfect match. Hard to tell the difference. Get it on Amazon.
Forum: General FSJ Tech 01-11-2020, 04:26 PM
Replies: 10
Views: 864
Posted By PBG928
ACC Custom Carpets are best. Buy direct or get...

ACC Custom Carpets are best. Buy direct or get them dropped shipped from BJ's Offroad.
Forum: General FSJ Discussion 01-11-2020, 08:19 AM
Replies: 8
Views: 676
Posted By PBG928
I have used their other colors with great...

I have used their other colors with great success. My steering wheels look brand new. Lightly sand, use SEM filler, paint and seal with their clear coat. Then you don't have to use the bubba wraps...
Forum: General FSJ Discussion 01-10-2020, 03:21 PM
Replies: 8
Views: 676
Posted By PBG928
Looks like SEM "Camel" is the closest...

Looks like SEM "Camel" is the closest color. Ordered a can from Amazon and will see how it goes.
Forum: General FSJ Discussion 01-10-2020, 08:54 AM
Replies: 8
Views: 676
Posted By PBG928
SEM Paint to match Honey interior

I am looking for the SEM paint code to match the Honey interior on my 1986 GW. I have used burgundy for the maroon interior and it worked great. Same for the tan. Need the code or their name for...
Forum: General FSJ Tech 12-10-2019, 07:05 PM
Replies: 6
Views: 515
Posted By PBG928
I have all parts. take off fenders with little...

I have all parts. take off fenders with little rust or other pair and hood have been sandblasted and painted white. Radiator and bumper. All except hood could be shipped via greyhound. Worth the...
Forum: General FSJ Tech 07-01-2019, 02:40 PM
Replies: 7
Views: 785
Posted By PBG928
Check two lines on passenger side of engine that...

Check two lines on passenger side of engine that vent fuel tank. Plug temporarily and see if performance improves.
Forum: Fuel Injection 06-25-2019, 07:08 AM
Replies: 15
Views: 3,943
Posted By PBG928
I don't think your stalling is due to timing...

I don't think your stalling is due to timing control. This is my second sniper system after the initial Howell efi. Howell had a DUI distributor, first sniper has an MSD with no box, and third had a...
Forum: Fuel Injection 06-24-2019, 03:51 PM
Replies: 15
Views: 3,943
Posted By PBG928
I just did the Holley 2300 with Hyperspark and...

I just did the Holley 2300 with Hyperspark and Robbmc powersurge fuel system. If you want to modify fuel lines and intake at tank you do not need the
Robbmc. Once dialed in it runs like a dream....
Forum: General FSJ Tech 06-24-2019, 03:10 PM
Replies: 1
Views: 533
Posted By PBG928
Solved missing issue

Solved it!. Shout out to Holley tech support for helping. I run a Sniper 2300 and put in Holley Hyperspark system which includes a coil, Distributor and ignition box. All plug and play with Sniper...
Forum: General FSJ Tech 06-18-2019, 05:59 PM
Replies: 1
Views: 533
Posted By PBG928
85 GW Engine missing

My 85 has a rebuilt motor with Holley Sniper that I recently added. vibrates and shakes at low idle and when accelerating. Checked time, replaced plugs and wires, New DUI distributor. Thought it may...
Forum: General FSJ Tech 05-26-2019, 07:29 AM
Replies: 11
Views: 1,261
Posted By PBG928
Yes it was the ground wire that is screwed into...

Yes it was the ground wire that is screwed into drivers inside wheel well that had been cut. Got it working so I can move car around.
Forum: General FSJ Tech 05-09-2019, 06:05 AM
Replies: 7
Views: 340
Posted By PBG928
It is tight but you can remove it with a plastic...

It is tight but you can remove it with a plastic prybar, Replace it with Steele https://www.steelerubber.com/extrusion-dense-70-2818-60. It is an identical match with tape on one side to hold it...
Forum: General FSJ Tech 05-09-2019, 06:00 AM
Replies: 14
Views: 651
Posted By PBG928
I had my 89 GW blasted with beads and water using...

I had my 89 GW blasted with beads and water using a $40k blasting machine. Worked out great. Yes there is left over sand that can be blown or vacuumed out. But nothing does a better job on rust...
Forum: Fuel Injection 05-02-2019, 01:44 PM
Replies: 21
Views: 6,720
Posted By PBG928
Finally got Robbmc and Holley Sniper installed....

Finally got Robbmc and Holley Sniper installed. Engine actually started. Have to fix a few other things before I can let it warm up and start learning. LCD screen is way cooler than the 1950 style...
Forum: General FSJ Tech 04-29-2019, 07:55 AM
Replies: 4
Views: 448
Posted By PBG928
Get this from Steele Rubber. Identical profile...

Get this from Steele Rubber. Identical profile with double stick tape. Works great.
https://www.steelerubber.com/extrusion-dense-70-2818-60
Forum: General FSJ Tech 04-29-2019, 07:43 AM
Replies: 12
Views: 1,537
Posted By PBG928
Gave up and welded section of roof from parts car...

Gave up and welded section of roof from parts car in and added new headliner. You might try this fellow as he bought the old sunroof and has experience with them. h-terrazas@sbcglobal.net
Forum: Fuel Injection 04-04-2019, 06:32 PM
Replies: 21
Views: 6,720
Posted By PBG928
Getting ready to install the Holley Sniper and...

Getting ready to install the Holley Sniper and the Robbmc mentioned above. with this set up do I really need the charcoal filter?
Showing results 1 to 25 of 74

 
Forum Jump

All times are GMT -6. The time now is 09:40 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
corner corner