International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 424
Search took 0.14 seconds.
Search: Posts Made By: stonehengeheels
Forum: General FSJ Tech 11-19-2014, 09:56 PM
Replies: 9
Views: 164
Posted By stonehengeheels
Cleaned the terminals today and still would not...

Cleaned the terminals today and still would not charge. Think I will get the battery tested when I have a chance and then take your testing advice. Thanks.
Forum: General FSJ Tech 11-16-2014, 07:55 PM
Replies: 9
Views: 164
Posted By stonehengeheels
Good advice gentlemen, thank you.

Good advice gentlemen, thank you.
Forum: General FSJ Tech 11-15-2014, 07:38 PM
Replies: 9
Views: 164
Posted By stonehengeheels
Well I just checked and now the charger is...

Well I just checked and now the charger is showing "Not Charging Battery" so I am off to the parts shop tomorrow. Anybody have a brand preference?
Forum: General FSJ Tech 11-15-2014, 06:23 PM
Replies: 9
Views: 164
Posted By stonehengeheels
'90 GW with no electrical

My GW ran last week and now I get no power anywhere. No lights, no nothing. Battery shows charged on my Battery Tender Jr. Anything jump out at you? Thanks.
Forum: General FSJ Discussion 11-15-2014, 06:22 AM
Replies: 6
Views: 141
Posted By stonehengeheels
I think the older ones have a metal end, not...

I think the older ones have a metal end, not plastic if you have a junkyard nearby.
Forum: General FSJ Tech 10-31-2014, 07:58 PM
Replies: 32
Views: 499
Posted By stonehengeheels
There was a post a while back where someone...

There was a post a while back where someone installed a short piece of rubber hose over the screws and then a piece of dowel, with a slot cut into the end, in the other end of the hose. Said it...
Forum: General FSJ Discussion 10-20-2014, 07:38 PM
Replies: 8
Views: 186
Posted By stonehengeheels
Can you install new wood grain on top of the old...

Can you install new wood grain on top of the old stuff?
Forum: General FSJ Discussion 10-20-2014, 07:24 PM
Replies: 9
Views: 215
Posted By stonehengeheels
I installed an additional headliner support...

I installed an additional headliner support between the existing headliner support and tailgate. It helped a lot. There is an existing brace to mount it to if you remove or don't have a headliner up.
Forum: General FSJ Discussion 10-20-2014, 07:21 PM
Replies: 8
Views: 186
Posted By stonehengeheels
I used a paint scraper on mine.

I used a paint scraper on mine.
Forum: General FSJ Discussion 10-20-2014, 07:18 PM
Replies: 2
Views: 141
Posted By stonehengeheels
Yes. I installed an extra brace, the one used to...

Yes. I installed an extra brace, the one used to hold the headliner up. I put some type of cushion (can't remember what I used) between it and the roof and it totally solved the roof sag and luggage...
Forum: General FSJ Tech 10-09-2014, 10:42 PM
Replies: 9
Views: 275
Posted By stonehengeheels
In an old Mustang I had I cut out the old floors...

In an old Mustang I had I cut out the old floors and pop riveted in new ones. Not OEM but it worked well. And it was free.
Forum: General FSJ Tech 09-30-2014, 08:39 PM
Replies: 3
Views: 98
Posted By stonehengeheels
I don't remember seeing one but I will check....

I don't remember seeing one but I will check. Thanks.
Forum: General FSJ Tech 09-30-2014, 07:13 PM
Replies: 3
Views: 98
Posted By stonehengeheels
No ideas?

No ideas?
Forum: General FSJ Tech 09-30-2014, 04:58 PM
Replies: 3
Views: 98
Posted By stonehengeheels
'90 GW Mirror Remote Control

How do I get this thing re-installed? I have the silver ring that was around it but I can never get it tight enough to stay in. Thanks.
Forum: General FSJ Discussion 09-23-2014, 11:08 PM
Replies: 10
Views: 248
Posted By stonehengeheels
My '90 had the same problem. I would pull it out...

My '90 had the same problem. I would pull it out of park and back in and it would start. Turned out that there was a ball bearing inside the tranny that held the shifter linkage in place. It had...
Forum: General FSJ Tech 09-22-2014, 09:51 PM
Replies: 16
Views: 297
Posted By stonehengeheels
Bad fuel pump was the cause. As Tripwire said I...

Bad fuel pump was the cause. As Tripwire said I had pressure but not volume.
Forum: General FSJ Discussion 09-18-2014, 09:42 PM
Replies: 1
Views: 126
Posted By stonehengeheels
90 GW interior door wood grain

Has anyone replaced the wood grain above the door panel below the window?
Forum: General FSJ Tech 09-17-2014, 09:05 PM
Replies: 16
Views: 297
Posted By stonehengeheels
Well, I pulled off the carb top today and bowl...

Well, I pulled off the carb top today and bowl was dry. Pulled the needle and seat and cleaned both, same problem. It ran until the bowl was empty. I will install the new sock from BJ's that is on...
Forum: General FSJ Tech 09-16-2014, 09:30 PM
Replies: 4
Views: 148
Posted By stonehengeheels
How would it have gotten past the extended float...

How would it have gotten past the extended float and pick up tube axis?
Forum: General FSJ Tech 09-16-2014, 07:41 PM
Replies: 16
Views: 297
Posted By stonehengeheels
Well, I am getting fuel all the way to the carb....

Well, I am getting fuel all the way to the carb. Gave it a few good whacks with a hammer and still no gas. I would think even with low flow (I get over 4.5 lbs out of the pump) the bowl would fill...
Forum: General FSJ Tech 09-15-2014, 06:04 PM
Replies: 16
Views: 297
Posted By stonehengeheels
Is that the line feeding the carb? Also is the...

Is that the line feeding the carb? Also is the support structure inside the pick up flat or is it supposed to be solid round like a tube? Mine was a little of both.
Forum: General FSJ Tech 09-15-2014, 02:27 PM
Replies: 16
Views: 297
Posted By stonehengeheels
Here is where I am at. Pulled the sending unit...

Here is where I am at. Pulled the sending unit and sock looks good. Black colored, is that the stock color? Still had some type of frame inside it. Easy to blow or suck through. Tested the fuel pump...
Forum: General FSJ Tech 09-14-2014, 05:06 PM
Replies: 2
Views: 81
Posted By stonehengeheels
Thanks.

Thanks.
Forum: General FSJ Tech 09-14-2014, 09:11 AM
Replies: 18
Views: 337
Posted By stonehengeheels
How do you remove the unit from the tank? Do you...

How do you remove the unit from the tank? Do you unscrew what appears to be a large nut that is on top?
Forum: General FSJ Tech 09-14-2014, 09:04 AM
Replies: 2
Views: 81
Posted By stonehengeheels
'90 GW Fuel Sending Unit Removal

So I pulled up the duct tape secured piece of cardboard over the tank access panel. Aside from disconnecting the hoses and wires how do I remove the actual unit?
Showing results 1 to 25 of 424

 
Forum Jump

All times are GMT -6. The time now is 10:55 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
corner corner