International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.10 seconds.
Search: Posts Made By: babywag
Forum: Fuel Injection Yesterday, 04:00 PM
Replies: 33
Views: 276
Posted By babywag
ARJU looks like ~16* timing @idle warmed...

ARJU looks like ~16* timing @idle warmed up.
Initial is 0*
Also appears to add ~10* when cold.

So *if* idles on its own/warmed up timing light should show ~16*.
Forum: Fuel Injection Yesterday, 01:27 PM
Replies: 33
Views: 276
Posted By babywag
Looked @ ARJT if that's what you have initial...

Looked @ ARJT if that's what you have initial "should" be 0*.

However, since it won't start/run properly...
Maybe try setting it 10* advanced while cranking?
.bin appears to ADD ~10* when...
Forum: Fuel Injection Yesterday, 12:38 PM
Replies: 33
Views: 276
Posted By babywag
In that pic, the engine is @ #1 TDC? How is the...

In that pic, the engine is @ #1 TDC?

How is the pickup/advance plate locked down?
Forum: Fuel Injection Yesterday, 12:10 PM
Replies: 33
Views: 276
Posted By babywag
Same as normal setup... Align rotor with your #1...

Same as normal setup...
Align rotor with your #1 on cap when installing distributor.
#1 can be any post on cap provided plug wires installed to match that position.

If proper alignment cannot be...
Forum: General FSJ Tech Yesterday, 08:38 AM
Replies: 4
Views: 107
Posted By babywag
It may work or it may not? As you said height is...

It may work or it may not?
As you said height is an unknown.
Also spring eye sizing may make finding correct post mount style bushing(s) difficult?
Forum: Fuel Injection Yesterday, 08:30 AM
Replies: 33
Views: 276
Posted By babywag
I would focus on timing...if you're confident in...

I would focus on timing...if you're confident in distributor install and you believe it is retarded adjust it.
with timing set wire disconnected the ecm doesn't alter timing
Forum: Fuel Injection 04-08-2020, 10:16 PM
Replies: 33
Views: 276
Posted By babywag
That would suggest timing is way off... I mean I...

That would suggest timing is way off...
I mean I can see mine when it's way advanced @idle:confused:
I painted the groove on the balancer with some nice bright yellow paint.
Forum: Fuel Injection 04-08-2020, 07:10 PM
Replies: 33
Views: 276
Posted By babywag
Did you unplug the timing set wire connector?

Did you unplug the timing set wire connector?
Forum: General Chit-Chat 04-08-2020, 01:34 PM
Replies: 51
Views: 1,138
Posted By babywag
I believe TX was the first area...? Pretty sure...

I believe TX was the first area...?

Pretty sure it'll be a requirement for all "essential" places everywhere very soon?? Meaning if you head to a grocery store etc. probably deny you entry without...
Forum: General FSJ Tech 04-08-2020, 12:45 PM
Replies: 6
Views: 57
Posted By babywag
If it's a 3-way cat(likely) it'll do just fine...

If it's a 3-way cat(likely) it'll do just fine without air injection.
Major differences in a 1980-ish CAT vs 2000-ish+.
Original 80s OEM CATs used on these weren't great.
But nobody can really tell...
Forum: General FSJ Tech 04-08-2020, 11:04 AM
Replies: 6
Views: 57
Posted By babywag
Most modern CATs do just fine without air...

Most modern CATs do just fine without air injection.
Many universals come w/o a port for air.
Any that do come with a port it is usually already capped off.

If it was me I'd just yank it all:eek:
Forum: General FSJ Tech 04-08-2020, 09:13 AM
Replies: 6
Views: 57
Posted By babywag
Just remove the tube and cap/pinch off @...

Just remove the tube and cap/pinch off @ converter.
Makes no sense to keep it if deleting air pump junk.
Forum: General Chit-Chat 04-08-2020, 08:58 AM
Replies: 51
Views: 1,138
Posted By babywag
They handed out 25 citations to folks @beach...

They handed out 25 citations to folks @beach watching sunset or enjoying a family picnic out here in Encinitas a few days ago.
TOTAL BS!

A sheriff made a statement in riverside county may start...
Forum: Fuel Injection 04-07-2020, 01:20 PM
Replies: 33
Views: 276
Posted By babywag
Your choice...both mine only have/use 2 relays

Your choice...both mine only have/use 2 relays
Forum: Fuel Injection 04-07-2020, 12:33 PM
Replies: 33
Views: 276
Posted By babywag
Small wires from coil pink/white go only to...

Small wires from coil pink/white go only to module.
Should NOT get power from elsewhere.
Only large gauge coil wire should get power in crank/run positions.

Here is a GM wiring diagram I simplified...
Forum: Fuel Injection 04-06-2020, 02:03 PM
Replies: 33
Views: 276
Posted By babywag
ARJU sounds familiar CA-only .bin iirc Have you...

ARJU sounds familiar CA-only .bin iirc

Have you checked for codes?

Do you have ability to read/burn or swap a diff chip?
Forum: General Chit-Chat 04-06-2020, 11:01 AM
Replies: 51
Views: 1,138
Posted By babywag
Crossing fingers/toes that your trip will be...

Crossing fingers/toes that your trip will be good/uneventful! Hopefully, everyone on the team and the ship stay virus-free!!
Forum: Fuel Injection 04-06-2020, 10:55 AM
Replies: 33
Views: 276
Posted By babywag
I run them @ 0 degrees and let the computer do...

I run them @ 0 degrees and let the computer do timing.

Some folks for whatever reason cannot do 0 degrees.
If not 0 degrees the .bin needs to match the initial timing and the timing table needs to...
Forum: Fuel Injection 04-06-2020, 10:33 AM
Replies: 33
Views: 276
Posted By babywag
Also if this is a "new" made in China...

Also if this is a "new" made in China module YES it could be bad...
many many instances of new aftermarket junk right out of the box.
Forum: Fuel Injection 04-06-2020, 10:31 AM
Replies: 33
Views: 276
Posted By babywag
Distributor a tooth off? Or plug wires 1 position...

Distributor a tooth off? Or plug wires 1 position off?
Forum: Fuel Injection 04-06-2020, 10:24 AM
Replies: 33
Views: 276
Posted By babywag
You may need a diode on the alternator wire to...

You may need a diode on the alternator wire to resolve the run-on with key off issue...had to do that on my 90GW.

Try reversing the distributor pickup wires. They will cause big issues if...
Forum: General FSJ Tech 04-04-2020, 09:33 AM
Replies: 15
Views: 184
Posted By babywag
Did you disconnect the throttle cable @ carb to...

Did you disconnect the throttle cable @ carb to make sure the throttle plates are fully closing?

While rare, I have seen a cable fail on more than one vehicle that prevented full closure of the...
Forum: General FSJ Tech 04-03-2020, 06:56 PM
Replies: 15
Views: 184
Posted By babywag
very the throttle is actually closing all the...

very the throttle is actually closing all the way?

other possibilities loose distributor and now waaaay advanced?
Forum: Fuel Injection 04-03-2020, 06:54 PM
Replies: 1
Views: 76
Posted By babywag
Been sooo many years but pretty sure all you...

Been sooo many years but pretty sure all you select is ecm type 1227747?
That is *if* that is the ecm you're running.
Old GM OBDI systems are 160baud

Comport = matching whatever aldl cable shows up...
Forum: Build Threads 04-03-2020, 09:02 AM
Replies: 481
Views: 34,575
Posted By babywag
:funny: :alc:

:funny: :alc:
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 06:02 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
corner corner