International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 61
Search took 0.03 seconds.
Search: Posts Made By: chakaD460
Forum: General FSJ Tech 10-11-2007, 04:27 AM
Replies: 18
Views: 1,967
Posted By chakaD460
I say go for a new unit, but you can attempt to...

I say go for a new unit, but you can attempt to check your speaker wires. If they are loose or shorted they will do what you described in your fourth bullet.

In an attempt to save your stock radio...
Forum: General FSJ Tech 10-09-2007, 05:53 PM
Replies: 2
Views: 1,050
Posted By chakaD460
front driveshaft pretzeled

Is it possible to repair the stock front driveshaft?

I was changing the oil and checking the underside of the J10 and noticed that the front driveshaft was twisted (looked at least 180deg twist). A...
Forum: General FSJ Tech 09-10-2007, 04:45 PM
Replies: 30
Views: 1,735
Posted By chakaD460
I have a 1.21 on my stock 258 now. And it runs...

I have a 1.21 on my stock 258 now. And it runs much better then the previous BBD. I had bought the carb and then found out about the 1.21 venturi later on. Has not been a problem. However, I do not...
Forum: General FSJ Tech 07-31-2007, 08:40 PM
Replies: 10
Views: 624
Posted By chakaD460
Yes. Did you disconnect the vacuum tube from the...

Yes. Did you disconnect the vacuum tube from the dist and plug it while you adjusted the timing.

Even with the vacuum line removed from the dist. You should see the timing move from the mechanical...
Forum: General FSJ Tech 07-30-2007, 04:22 PM
Replies: 16
Views: 4,298
Posted By chakaD460
Did you clean the heads out well? I had to get...

Did you clean the heads out well? I had to get some PB and a small pick to get it all out. Then the allen I had out of a standard set fit. Not sure what size it is though.
Forum: General FSJ Tech 06-24-2007, 08:42 PM
Replies: 8
Views: 824
Posted By chakaD460
Is it true that the water from a dehumifier is...

Is it true that the water from a dehumifier is distilled?
Forum: Off-Road FSJ Tech 06-03-2007, 04:41 PM
Replies: 7
Views: 626
Posted By chakaD460
I am thinking the same. Throw a ohm meter on it...

I am thinking the same. Throw a ohm meter on it and test for continuity w/ and w/out pressure.
Forum: General FSJ Tech 04-28-2007, 08:00 AM
Replies: 7
Views: 898
Posted By chakaD460
I will be able to take some measurements today....

I will be able to take some measurements today. However I have 31" tires not stock.
Forum: General FSJ Discussion 04-20-2007, 03:34 PM
Replies: 24
Views: 1,008
Posted By chakaD460
Bummer. :( Sorry for the bad advice.

Bummer. :( Sorry for the bad advice.
Forum: General FSJ Tech 04-20-2007, 03:31 PM
Replies: 14
Views: 2,379
Posted By chakaD460
I had the same problem on an F-150. Turned out I...

I had the same problem on an F-150. Turned out I didn't take the c-clips off the caps. After that they popped off with a solid hit and some sockets.

PB Blast it and let it sit for an hour or so.
Forum: General FSJ Discussion 04-20-2007, 04:20 AM
Replies: 52
Views: 7,396
Posted By chakaD460
The show makes you sign a contract stating you...

The show makes you sign a contract stating you will not sell the vehicle for a certain timeperiod.

IRC the first two people or so on the show did just that.
Forum: General FSJ Discussion 04-20-2007, 04:16 AM
Replies: 24
Views: 1,008
Posted By chakaD460
You can use clearcoat. Autozone sells spray cans...

You can use clearcoat. Autozone sells spray cans of it.
Forum: General FSJ Tech 04-19-2007, 08:07 PM
Replies: 17
Views: 968
Posted By chakaD460
Ditto. Being a noob to a FSJ I didn't realize...

Ditto. Being a noob to a FSJ I didn't realize that when the needle is at a quarter tank it is really empty.
Forum: General FSJ Discussion 04-17-2007, 10:45 AM
Replies: 13
Views: 935
Posted By chakaD460
Company has a Fisher Minute Mount II. Easy to...

Company has a Fisher Minute Mount II. Easy to remove and install. All that is on the truck w/ the plow off is the mounting tabs that are under the bumper. Somwhat hidden and the three plugs for the...
Forum: Off-Road FSJ Tech 04-15-2007, 03:51 PM
Replies: 90
Views: 12,904
Posted By chakaD460
Awesome work. I just finished reading through....

Awesome work. I just finished reading through. Wish I had as much motivation.
Forum: General FSJ Tech 04-12-2007, 08:01 PM
Replies: 3
Views: 621
Posted By chakaD460
Are you sure of your fuel supply?

Are you sure of your fuel supply?
Forum: General FSJ Tech 04-12-2007, 05:09 PM
Replies: 6
Views: 706
Posted By chakaD460
Here is some links with all the...

Here is some links with all the parts:

http://www.4x4xplor.com/tfi.html

http://keith.cj8.tripod.com/tfi_upgrade.htm
Forum: General FSJ Tech 04-12-2007, 10:15 AM
Replies: 8
Views: 594
Posted By chakaD460
I plan on doing a 4.5 swap in the future. Will...

I plan on doing a 4.5 swap in the future. Will any 258 clutch work since the 4.5 stroker is using the 258 crank and thus flywheel. (IRC I read the bolt pattern is different.)
Forum: General FSJ Tech 04-11-2007, 04:33 PM
Replies: 0
Views: 624
Posted By chakaD460
4.5 swap questions

I have been searching, but still can't find what I need. What clutch kit will I need to use for a 4.0 bolted to a T-178? I may be getting a good deal on a 94 Cherokee.

If it goes through. looking...
Forum: General FSJ Tech 04-11-2007, 03:21 PM
Replies: 5
Views: 460
Posted By chakaD460
You bench bled the MC, right? It will take...

You bench bled the MC, right?

It will take forever to bleed properly if you didn't. You started at the farthest point and bleed forward, right?

I would just keep bleeding. There is an air bubble...
Forum: General FSJ Tech 04-05-2007, 07:27 PM
Replies: 8
Views: 594
Posted By chakaD460
clutch and transmission

Hey guys, What manual 4 speed do I have in my 87 J10? It is between a 258 and a 208. I don't think it is a T18 because there is no PTO port on the pass side. Was curious. Will have to climb under...
Forum: General FSJ Tech 04-05-2007, 02:14 PM
Replies: 12
Views: 1,257
Posted By chakaD460
I had this problem on a Saab. Turn the hazards on...

I had this problem on a Saab. Turn the hazards on and the fuel gauge would bounce and the right blinker made the temp gauge bounce.

Changed out the instrument cluster and all was well. I think the...
Forum: General FSJ Tech 04-04-2007, 03:16 PM
Replies: 17
Views: 1,405
Posted By chakaD460
Same with the Herculiner. I really like the...

Same with the Herculiner.

I really like the Herculiner.
Used it on the bed of my work van and it helped to reduce the noise and keeps my things from sliding. However, I prepped the hell out of it....
Forum: General FSJ Discussion 04-02-2007, 07:07 PM
Replies: 71
Views: 3,795
Posted By chakaD460
Not to hijack, but how do you get to the FI...

Not to hijack, but how do you get to the FI site?

I keep getting this error: PHP has encountered an Access Violation at 018B51CA
Forum: General FSJ Tech 04-01-2007, 07:23 PM
Replies: 4
Views: 866
Posted By chakaD460
:D The motor won't be coming out of the torino....

:D The motor won't be coming out of the torino. Too much fun to drive.

Isn't the 351C as wide as the 460?

What about a 400M or 351M? I have one sitting that needs a rebuild. Were would I beable...
Showing results 1 to 25 of 61

 
Forum Jump

All times are GMT -6. The time now is 02:51 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
corner corner