International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: The Colonel
Forum: General FSJ Discussion 11-30-2015, 04:12 PM
Replies: 10
Views: 921
Posted By The Colonel
Transgo has decent kits, I've never had any...

Transgo has decent kits, I've never had any issues with them
Forum: General FSJ Tech 08-17-2013, 10:55 PM
Replies: 59
Views: 2,292
Posted By The Colonel
Voltage drop on your battery/starter cables. Also...

Voltage drop on your battery/starter cables. Also check the ground from the engine block to the frame rail.

Make yourself new cables using welding calble.
Forum: General FSJ Tech 08-16-2013, 09:39 PM
Replies: 9
Views: 476
Posted By The Colonel
The 727 TQ will only bolt up one way. Also the...

The 727 TQ will only bolt up one way. Also the weight on the flexplate will prevent you from turning it with the trans bolted up. Be sure to have it in the correct position before reinstalling the...
Forum: General FSJ Tech 07-10-2013, 09:40 PM
Replies: 23
Views: 1,373
Posted By The Colonel
Mickey Mouse called...said thanks for letting him...

Mickey Mouse called...said thanks for letting him wire up you rig.
Forum: General FSJ Tech 07-01-2013, 03:57 PM
Replies: 5
Views: 438
Posted By The Colonel
Check the resistance of the clutch coil. Normally...

Check the resistance of the clutch coil. Normally it's around 6 ohms. Unless the clutch is worn, just replace the coil if it has an open circuit.
Forum: General FSJ Discussion 05-17-2013, 11:46 PM
Replies: 44
Views: 1,821
Posted By The Colonel
Enough said. If it isn't broke, don't fix it.

Enough said. If it isn't broke, don't fix it.
Forum: General FSJ Discussion 05-17-2013, 11:41 PM
Replies: 28
Views: 2,790
Posted By The Colonel
Almost every axle out there lubes the bearings...

Almost every axle out there lubes the bearings with the gear oil, not grease. Packed grease will only last so long and there is no way to service this without pulling it all back apart. I'd remove...
Forum: General FSJ Tech 04-25-2013, 04:40 PM
Replies: 12
Views: 1,255
Posted By The Colonel
rust treatment

What is the best rust treatment for rusty body panels? Is POR 15 the way to go?

Does anyone know of local retailers that would carry that or a similar product?
Forum: General FSJ Tech 04-12-2013, 08:05 PM
Replies: 6
Views: 471
Posted By The Colonel
Is this for the 1980?

Is this for the 1980?
Forum: General FSJ Discussion 04-12-2013, 08:01 PM
Replies: 6
Views: 918
Posted By The Colonel
The cig outlet fuse is the one marked...

The cig outlet fuse is the one marked "ACC" and it's 20 amps.
Forum: General FSJ Discussion 04-12-2013, 07:54 PM
Replies: 6
Views: 500
Posted By The Colonel
Even the 86 GW had a 3 pin switch on the trans....

Even the 86 GW had a 3 pin switch on the trans. What color are the wires going to yours?
Forum: General FSJ Tech 04-11-2013, 12:48 PM
Replies: 14
Views: 486
Posted By The Colonel
In 2WD mode the NP229 chain isn't under any load....

In 2WD mode the NP229 chain isn't under any load. I'd look more at u-joints or diff backlash.
Forum: General FSJ Discussion 03-13-2013, 10:15 PM
Replies: 13
Views: 567
Posted By The Colonel
That's not what it means. It doesn't take a...

That's not what it means. It doesn't take a hybrid or a start-stop setup to be PZEV.
Forum: General FSJ Tech 03-02-2013, 02:58 PM
Replies: 240
Views: 12,699
Posted By The Colonel
Wow, streaming bluetooth- the redneck is moving...

Wow, streaming bluetooth- the redneck is moving into the 21st century.
Forum: General FSJ Discussion 01-21-2013, 03:34 PM
Replies: 5
Views: 493
Posted By The Colonel
If it's just a "nick" it should be fine.

If it's just a "nick" it should be fine.
Forum: General FSJ Tech 01-10-2013, 08:33 PM
Replies: 4
Views: 516
Posted By The Colonel
I've got the 89 diagrams here:...

I've got the 89 diagrams here: http://home.comcast.net/~amc_jeep/wiring_diagrams.htm
Forum: General FSJ Tech 01-10-2013, 08:29 PM
Replies: 6
Views: 404
Posted By The Colonel
The 19211 is the seal I used. I'm not sure on the...

The 19211 is the seal I used. I'm not sure on the 19244.

Here is another option for the bearing:...
Forum: General FSJ Tech 12-22-2012, 11:14 PM
Replies: 31
Views: 1,060
Posted By The Colonel
ATF pumps rarely go out. Try disconnecting the...

ATF pumps rarely go out. Try disconnecting the ATF cooler and see if it's pumping fluid out.
Forum: General FSJ Discussion 10-03-2012, 06:56 AM
Replies: 13
Views: 680
Posted By The Colonel
I bought a bearing for my Sanden for around...

I bought a bearing for my Sanden for around $20.
The clutch comes right off with a steering wheel puller:

http://i844.photobucket.com/albums/ab10/89GW360NP229Dana44/DSCN1605Medium.jpg
Forum: General FSJ Discussion 09-26-2012, 08:50 PM
Replies: 16
Views: 922
Posted By The Colonel
My $.02 .... if you need a "mechanic"...

My $.02 .... if you need a "mechanic" in case it breaks down...you probably shouldn't be buying an old beater to start with.



Just go buy a regular lawn ornament. I'm sure the city of Evanston...
Forum: General FSJ Tech 09-24-2012, 09:30 AM
Replies: 10
Views: 532
Posted By The Colonel
This may...

This may help:

http://home.comcast.net/~amc_jeep/NP229%20Disassembly.pdf

http://home.comcast.net/~amc_jeep/NP229%20Assembly.pdf
Forum: General FSJ Tech 09-23-2012, 08:07 PM
Replies: 3
Views: 360
Posted By The Colonel
The bearing is 22272A and the output seal there...

The bearing is 22272A and the output seal there is 12074J. Both are transtar numbers I listed.
Forum: General FSJ Discussion 09-21-2012, 03:01 PM
Replies: 13
Views: 621
Posted By The Colonel
They do, even the wiring diagram shows them.

They do, even the wiring diagram shows them.
Forum: General FSJ Tech 09-17-2012, 05:03 PM
Replies: 12
Views: 748
Posted By The Colonel
What he said. ^^^^^

What he said. ^^^^^
Forum: General FSJ Tech 09-08-2012, 10:21 AM
Replies: 8
Views: 486
Posted By The Colonel
What brand of filter was that one?

What brand of filter was that one?
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 03:34 AM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
corner corner