International Full Size Jeep Association
Home Forums Reader's Rigs Tech Library Trail Stories FSJ-List
International Full Size Jeep Association  

Go Back   International Full Size Jeep Association > Search Forums

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: AMC-J/20
Forum: General FSJ Discussion 12-28-2014, 01:22 AM
Replies: 34
Views: 3,341
Posted By AMC-J/20
Oh no it don't over heat it just actually warms...

Oh no it don't over heat it just actually warms up and as it does the heater starts really kickin out lots of hot air :thumbsup:

I am thinking need to partially cover the radiator.
Forum: General FSJ Discussion 12-27-2014, 01:30 PM
Replies: 34
Views: 3,341
Posted By AMC-J/20
I can pull into a parking lot after running...

I can pull into a parking lot after running around with my temp gauge reading like 105 or 115 degrees, heater blowing ice cold air. I then let it idle and within 15min my water temp gauge is reading...
Forum: General FSJ Discussion 12-27-2014, 10:23 AM
Replies: 34
Views: 3,341
Posted By AMC-J/20
Old post I know and sorry... Now the Grand Wag is...

Old post I know and sorry... Now the Grand Wag is doing the same thing but when I stop moving and just let it run parked my engine will eventually heat up to operating temp and start blowing HOT...
Forum: General FSJ Tech 05-03-2014, 03:50 PM
Replies: 16
Views: 957
Posted By AMC-J/20
Straight up? Its be mounted vertically? I mounted...

Straight up? Its be mounted vertically? I mounted it same is the old one input facing the drivers fender side and out puts facing toward the passenger fender... Or am I miss under standing?
Forum: General FSJ Tech 05-03-2014, 12:18 PM
Replies: 16
Views: 957
Posted By AMC-J/20
Did tune up/fuel filter, Now runs worse and leak gas!!!

I changed out my fuel filter then did a complete tune up. Plugs, wires, cap, and rotor. Replaced my 1in 2out fuel filter with a 1in 2out fuel filter. Engine now runs WAY WAY rougher then before and...
Forum: General FSJ Tech 04-10-2014, 02:54 PM
Replies: 5
Views: 686
Posted By AMC-J/20
Well then I best change the bearings ;) This was...

Well then I best change the bearings ;) This was sorta of a retired rig sat a few years, Push came to shove needed wheels and on the road it went. 5,000 miles later the radiator went it sat 3 weeks...
Forum: General FSJ Tech 04-07-2014, 03:19 PM
Replies: 5
Views: 686
Posted By AMC-J/20
Oh boy fun fun, Tie rods and ball joints time......

Oh boy fun fun, Tie rods and ball joints time... Should I do wheel bearings to?
Mike
Forum: General FSJ Tech 04-07-2014, 01:31 PM
Replies: 5
Views: 686
Posted By AMC-J/20
Stiff steering? Issue!

The '89 Grand-Wagoneer sat a while because of a radiator failure. Now my steering is very stiff. It has fluid but it does seems to be harder to steer then before the radiator failed. Any ideas?

It...
Forum: Diesel Swaps 04-05-2014, 06:43 AM
Replies: 114
Views: 39,111
Posted By AMC-J/20
24V-5.9L I6 Cummins diesel, ?Manual-Trans?,...

24V-5.9L I6 Cummins diesel, ?Manual-Trans?, NP241HD, D60-DRW front, and D80-DRW rear with 4.30 gears and 245/70R19.5s :thumbsup:

Mike
Forum: General FSJ Discussion 04-04-2014, 03:30 PM
Replies: 415
Views: 55,507
Posted By AMC-J/20
Talking I got about $900 into the '89 Grand-Wagoneer....

I got about $900 into the '89 Grand-Wagoneer. Runs and drives great with new 30" Bridgestone Dueler AT tires and HiPo aluminum radiator :thumbsup: I figure I basically bought the tires and radiator...
Forum: General FSJ Discussion 02-23-2014, 08:24 PM
Replies: 3
Views: 748
Posted By AMC-J/20
Well after page I got bord, long bed ext cab vs...

Well after page I got bord, long bed ext cab vs reg cab sht bed yep that's completely different and in no way related to what I'm doing... I am doing to "alike" trucks. Reg cab to Reg cab, long bed...
Forum: General FSJ Discussion 02-23-2014, 12:19 AM
Replies: 3
Views: 748
Posted By AMC-J/20
RAM2500 to Jeep J4000...

Will a 1971 Jeep J4000 body fit a 2002 RAM2500 diesel chassis? Not directly bolt up wise, But axle and wheel wells linning up wise?

Mike
Forum: General FSJ Discussion 02-14-2014, 12:35 AM
Replies: 2
Views: 596
Posted By AMC-J/20
I found it, It was on Amazon... Shepard auto's...

I found it, It was on Amazon... Shepard auto's FSJ Aluminum Radiator
:thumbsup:

Mike
Forum: General FSJ Discussion 02-13-2014, 07:42 PM
Replies: 2
Views: 596
Posted By AMC-J/20
Looking that cheap FSJ AL Radiator...

I'm looking for the Aluminum radiator it was on a website for $185. Now I can't find it any more... Anybody know where it was?

I forgot to bookmark it :mad:
Mike
Forum: General FSJ Discussion 02-11-2014, 06:32 PM
Replies: 12
Views: 943
Posted By AMC-J/20
Well I'm going to be running a D60/D80 DRW axle...

Well I'm going to be running a D60/D80 DRW axle combo under a shortened chassis for 14,000LB GVWR truck that had a towed load rating of 20,000lbs :thumbsup: This same frame/axles were used under...
Forum: General FSJ Discussion 02-11-2014, 11:47 AM
Replies: 288
Views: 46,555
Posted By AMC-J/20
Its beautiful! Great job I'm glad I got to see it...

Its beautiful! Great job I'm glad I got to see it finished up :thumbsup:

Mike
Forum: General FSJ Discussion 02-11-2014, 09:20 AM
Replies: 288
Views: 46,555
Posted By AMC-J/20
Came out great! I cheated I got my M48 6by from...

Came out great! I cheated I got my M48 6by from my wife and daughter
:thumbsup:

Mike
Forum: General FSJ Discussion 02-10-2014, 04:19 PM
Replies: 12
Views: 943
Posted By AMC-J/20
If you have all day to get there sure the 6...

If you have all day to get there sure the 6 leaker is a great engine... I have driven both a 2500HD 8.1 and a 6.0 2500HD at work and I can safely say yes the 6 leakier will do the job but the 8100...
Forum: General FSJ Discussion 02-10-2014, 03:45 PM
Replies: 12
Views: 943
Posted By AMC-J/20
Oh good I can get oil by the drum full... Losy...

Oh good I can get oil by the drum full... Losy fuel mileage? Well that's news to who? I didn't figure hauling a duece on goose neck was going to net 50 miles per gallon... Cummins? Diesel? Ha! Never!...
Forum: General FSJ Tech 02-10-2014, 03:25 PM
Replies: 22
Views: 2,458
Posted By AMC-J/20
Well did ya do it? I am thinking about an 8100...

Well did ya do it? I am thinking about an 8100 myself... Its a toss up between a TBC-427 from a C60 or C70 to a modern version 427 EFI known as the 7.0L for a 6500/7500 or the 8.1 used in...
Forum: General FSJ Discussion 02-10-2014, 03:05 PM
Replies: 12
Views: 943
Posted By AMC-J/20
From what I gathered the 7.0L is an updated fuel...

From what I gathered the 7.0L is an updated fuel injected 427 so I think it's still a TBC or Tall Block Chevy... The 427 eventually got replaced with a 454 which I think was just a big block rather...
Forum: General FSJ Discussion 02-10-2014, 01:15 PM
Replies: 12
Views: 943
Posted By AMC-J/20
TBC-427/7.0L... Or... VT-8.1L

I have a neat question, building a J4000 goose neck pulling rig. I'd like to go with GM-427 tall block C60+ or Modern 7L C6500+ dump truck engine. 260hp@3800rpm and 405tq@2,600rpm. But I also was...
Forum: General FSJ Discussion 02-09-2014, 09:44 PM
Replies: 288
Views: 46,555
Posted By AMC-J/20
:D Beautiful 6by looks like it came out awesome...

:D Beautiful 6by looks like it came out awesome :thumbsup:

Mike
Forum: General FSJ Tech 02-09-2014, 09:34 PM
Replies: 176
Views: 22,647
Posted By AMC-J/20
I run 10w-40 during the winter and 20w-50 during...

I run 10w-40 during the winter and 20w-50 during the summer :cool:
AMSOIL premium protection high zinc formula :thumbsup:

They have a new high oil called Z-Rod in 10-30 and 20-50 too.
Mike
Forum: General FSJ Discussion 02-09-2014, 09:18 PM
Replies: 3,495
Views: 252,371
Posted By AMC-J/20
The fan shroud took out the good radiator coming...

The fan shroud took out the good radiator coming back from Chicago and after swapped it out for the old spare one it started pissing coolant on the ground as I filled it up :mad: before I even...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 11:25 PM.


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
corner corner