7747 doesn't care which sensor return is on A11 or D2, right?
OK, just got done verifying all the correct wires are to the correct pins and that they have continuity to the connector. The only issues I had were sensor returns on A11 and D2. ECM doesn't really care which sensor goes where since they are both grounds, Right?
This diagram just shows them as "Sensor Ground" and says either MAP or TPS (based on wire colow) can go to either pin.
This one show MAP going to D2 (mine goes to A11) and TPS going to A11 (mine goes to D2).
I don’t believe it matters, easy to swap pins if for whatever reason it doesn’t.
|All times are GMT -6. The time now is 11:26 PM.|
Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.