Non-FSJ - 4.0L filter adapter

[turtlejoe]

Sorry it's not FSJ related, but someone here has got to know how to R&R the oil filter adapter on a 4.0L, 1993 Grand Cherokee. Neither Haynes nor Chilton even mention the part, and Chrysler was only able to sell me the O-ring (well, it's one of these 3) but not show how to remove it. There don't appear to be any obvious fasteners visible so I'm a bit confused.

It's my wife's car, and she's distraught that her car is actually leaking more than mine.

As usual, any help is greatly appreciated.

Kerry :rolleyes:

[J10/J20 Project]

turtlejoe, i think it is a torx. There isn't room to fit the socket and wrench so i had to use visegrips around the torx. It just takes time. little turn at a time. It is pretty straight forward. 2 seals on the bolt and the other for the housing to the block.

[heydave]

I found this article. Maybe it will help.
http://www.madxj.com/
OK, that is the home page. Go to the engine tech and there is an article about changing that adapter.

[ November 25, 2002, 08:47 PM: Message edited by: HeyDave ]

[J10/J20 Project]

HeyDave good link. That is the one I used when I upgraded my 88.

[turtlejoe]

Wow, once again I'm amazed at the collective knowledge on this board. HeyDave, thanks for the link and information. I'll take a peak and pick up the Torx tomorrow.

Thanks again ...