360's for sale.....

[Guru]

What should I expect to pay for a good running,stock 360 and what are my options?Does the 401 sit right in place of the 360?:confused:

[AlsChopShop]

401 is demensionally the exact same as the 360, so it will bolt right up.

your market may vary, but i sold my running 360 with 100k miles for $100. i could have probably gotten $150 or even $200 had i cared much about it, but it went to a wheelin buddy that is going to put it in a CJ10a tug wheeler project.

Al

[Guru]

there is a guy who's got a real decent 360 "he says" wants 350?

[Brizio]

There is one on CL for 200. Looks good.

[FSJ Guy]

$200, tops. These are not highly sought after motors. Of course, a 401 will bring more, but it's well known on this board that they're not worth more than $100 or so, esp. when wrapped in a 70's Wagoneer. ;)

[babywag]

I sold the below 360's in the past couple years;
$600 rebuilt w/ edlebrock intake and carb complete
$150 (x2) cores long blocks
$50 core shortblock rebuilder sold to a member on here
$50 longblock ran good sold to a member on here

Prices will vary depending on your locale
I wouldn't pay more than $150 unless you can do a compression test, and hear it run.
Or, your buying it from a yard that will warranty it as a good engine.

[Guru]

Ok, thanks for the input.I will see if I can get him down...or maybe warrenty it.

[Tornado230]

Buy a running piece. Pull the motor. If you're lucky, you will end up with other parts you can use.

[jrlane]

Hey Guru I don't know where your at in Tn But I,m in Shelbyville Tn. I have a 360 out of a 1978 J-10. It is complete and Ran good when I pulled it. I will take $100.00 for it. PM me if interested. Thanks


Junior

[funhog]

Try and get it complete. The little brackets and acc. will nickel and dime you to death.

[Guru]

amen to that.