Here we go again!

[swclemons]

I hate my 2150!! I have had the thing rebuilt 3 times every time back to the same problem. When I dump on the gas it wants to stall, If I ease on the gas no problems.

I think its time for a new Carb....

Steve
87GW Stock

[porkchop]

Did you check out the post on the carb plate? It might cure your problem.

------------------
'67/'79 Wagoneer mix
“Old Timer”
Check it out! (http://members.fortunecity.com/porkchopsfsj)

Mods, Mods, and more Mods! The end is no where in site, but I am sure I am closer to the fork in the road.

[jeepbob]

That or a little more timing. You did make sure the accel pump on the carb was working and adj properly, right?

------------------
65 wag. 360/edelbrock rb4/t400/20 t-case/4:10 d27/d44 tracloc/onboard air/onboard 110v power(no inverter)/1999 Lincoln t.c.leather buckets/taurus ctr console/winch/33x12.50/tunes/water proof door pads
soon to have new motor/d44frt/d60r(4:10)welded diff/custom bumpers
see ya in da mud

[swclemons]

The Acc Pump was the problem the last time, and I am suspecting it again, however I am going to check the Carb Plate. If I decide to get a new Carb which one is best???

Steve

[jeepbob]

There are many different opinions here, check a little further back in this forum, and you will find a couple of good debates.
(I like my Holly 4160)

------------------
65 wag. 360/edelbrock rb4/t400/20 t-case/4:10 d27/d44 tracloc/onboard air/onboard 110v power(no inverter)/1999 Lincoln t.c.leather buckets/taurus ctr console/winch/33x12.50/tunes/water proof door pads
soon to have new motor/d44frt/d60r(4:10)welded diff/custom bumpers
see ya in da mud