TFI coil hook up ? question

[drives mopars]

on a 84 360 has the coil with the resistor thing on top

how do i hook up the wires i did buy the plug for the coil top

and do i use a condensor?
i did read the info on this setup but somewhat still confused on the wired
are the colors reversed as one info sheet said?
i really need hook what color to what color wire

thank you in advance bill

[gpd]

I copied this off the site I used. As I remember, you do have to reverse the wires. Hope it helps

__________________________________________________
When upgrading to a TFI coil on a factory ignition system, some attention has to be paid to the voltage POLARITY. If you hold a 'Can' coil with the Primary 'horseshoe' connector at the top, above the high voltage tower, the Primary Green wire, Negative, is on the Left, and the Primary Red wire, Positive, is on the Right.

If you hold a TFI coil with the Primary connector at the top, and the high voltage tower at the 6 o'clock position, the wiring hookup is reversed. With the TFI coil, the Primary Positive, Red wire, is on the Left, and the Primary Negative, the Green wire, is on the Right. If you look into the Primary Connector, the polarity is usually marked there (/-).

http://fsjeep.homestead.com/TFI_Upgade.html
http://www.ifsja.org/tech/electrical/ignitionupgrade.shtml