Da Big Blue
04-21-2003, 05:47 PM
Ok i finally went on my first offroad adventures yesterday. it was all fun driving threw mud and creeks until I went to put it back into 2wheel drive.
When i first got ogg road i tried putting it in 4LOW but couldn't get it in, slid into 4high fine though. I finally got it into 4LOW. after pulling off the trail onto the road again, i go to but it back into 2wheel and the shifter knob was completing free moving. there is NO tention on it at all. I am guessing i did somthing while driving over a field full of bushes. So basically how do i get it out of 4Wheel and hooked back up properly? i need to go to work but fear wreking the t-case.
HELP!
When i first got ogg road i tried putting it in 4LOW but couldn't get it in, slid into 4high fine though. I finally got it into 4LOW. after pulling off the trail onto the road again, i go to but it back into 2wheel and the shifter knob was completing free moving. there is NO tention on it at all. I am guessing i did somthing while driving over a field full of bushes. So basically how do i get it out of 4Wheel and hooked back up properly? i need to go to work but fear wreking the t-case.
HELP!