EGR Vaccume line

[ChrisCollege]

I think my EGR valve is connected to the wrong vaccume lines. Starting at the EGR it goes to a purple in line plastic disk (vaccume dump) then it tees and goes to the air cleaner housing and the charcole canaster. When I review the vaccume diagram for my 88GW 360 it seems the diagram says it should go to the forward CTO and some were else I can't quite remember with out looking at the diagram. Can some one confirm the corect routing?

Thanks Chris

[ChrisCollege]

Anyone familiar with their routing on the EGR?

[joe]

Originally posted by ChrisCollege:
When I review the vaccume diagram for my 88GW 360 it seems the diagram says it should go to the forward CTO and some were else I can't quite remember with out looking at the diagram. Am I missing something here Chris? Why not just look at the diagram again and hook it up that way?
I doubt an 88 is different than an 89 but on an 89 the egr hose goes to the delay valve then egr/tvs then it T's off with one hose going to the lower nipple of the two nipples on the dual CTO(3 nipples on the other side). The other hose goes to the charcoal canister.

[ChrisCollege]

Thanks. Just wanted to make sure I was reading the diagram correctly. Does any one have a legend for all the abbreviations on the vaccume diagram?