If all you have is a throttle body...

[scantar]

...what else would you need to convert to F.I.?

[Cecil14]

Well you're going to need a motor to put it on at some point. :D sorry...couldn't resist.

I would say a wiring harness from a similar year (to your TB) GM 350 or so would be a good start. That's the nice part about the GM TBI, it's really pretty stand alone. It doesn't care what engine it's on, though you will need to tune it to match your exact engine specs.


aa

[scantar]

Well you're going to need a motor to put it on at some point. :D sorry...couldn't resist.


aa


Well there goes my gas mileage hopes :rolleyes:

[Ristow]

Well you're going to need a motor to put it on at some point. :D sorry...couldn't resist.
aa

LOL!


steve,have you been licking the wiring again.....?

[Wagoneerlover]

...what else would you need to convert to F.I.?

Scantar check the tech section under engine. I did an article there that list every piece you need piece by piece. Read it thoroughly and you will understand exactly what you need. If you have any further questions then pm me.

[scantar]

Scantar check the tech section under engine. I did an article there that list every piece you need piece by piece. Read it thoroughly and you will understand exactly what you need. If you have any further questions then pm me.

Whew...thanks for talking me down. Reading through that was a total buzzkill. Great writeup!:thumbsup:

Not an upgrade I'm going to do on THIS Jeep methinks.

[Billygoat]

Afraid the Jeep might win again?

Not sure what Throttle body you have, but Howell Engine might be able to help you get everything you need.
http://www.howellefi.com/shop/customer/home.php

[scantar]

Afraid the Jeep might win again?




Win? I'd be tapping out before I finshed looking at all the parts. :D