Where can I purchase these?

[FSJeep13]

When I did my body lift I figured I'd be ok with the squished rubber mount, but now that I want to get my bumpers adjusted properly at the shop I'm thinking that I'd better do it now instead of having a problem later.

Where can I get two replacement rubber mounts? They must be fairly universal, rubber puck with a hole in it... The other mounts are fine. I don't want to replace them all.

http://i48.photobucket.com/albums/f226/FSJeep13/wagoneer047.jpg

[ChiefTawny]

http://www.bjsoffroad.com/cartgenie/prodInfo.asp?pid=24&cid=8

[76'wago]

hockey pucks work pretty good, cheap on ebay

[shackwrrr]

4wd hardware sells it by the 2 foot sections

http://www.4wd.com/productdetails.aspx?partID=7128

just cut how much you need

[AlsChopShop]

i thought the bushing goes on the top of the block, so it isn't squished? also there should be big fender washers on both sides to prevent it from warping over the frame like that.

Al

[FSJeep13]

i thought the bushing goes on the top of the block, so it isn't squished? also there should be big fender washers on both sides to prevent it from warping over the frame like that.

I know the kit said to install the blocks on top of the bushings... It would still be squished on the other side I think. Also There were not any washers, just that rubber spacer on the front end. It was warped like that already, but after tightening it down, it got worse.

I might be doing that two foot section unless I can find something from one of the local 4x4 stores.

[TPICherokee]

Whose kit did you buy? The bushings all go on top of the pucks, they kind of have to because they have sleeves in them that keep them on the brackets.

[FSJeep13]

Whose kit did you buy? The bushings all go on top of the pucks, they kind of have to because they have sleeves in them that keep them on the brackets.

Performance Accessories
http://static.summitracing.com/global/images/instructions/pra-pa-902.pdf

I'm pretty sure we did this right, but maybe I made a mistake.