high flow cat

[misfittom138]

Installed my high flow cat and flowmaster exhaust today. Sounds awesome, runs great. New cap, rotor, wires, plugs... I should be close to passing emissions now. Just need new air pump as mine is going out and making quite a racket. It's getting there though, one step at a time. :thumbsup:

[rock&roll]

Installed my high flow cat and flowmaster exhaust today. Sounds awesome, runs great. New cap, rotor, wires, plugs... I should be close to passing emissions now. Just need new air pump as mine is going out and making quite a racket. It's getting there though, one step at a time. :thumbsup:

i just pulled the air pump off my 79 if you want it ill give it to ya for the cost of shipping. Also...
:worthless:

[misfittom138]

i just pulled the air pump off my 79 if you want it ill give it to ya for the cost of shipping. Also...
:worthless:

Hard to get pics from under there but I will try. And I may take you up on that offer! :thumbsup:

[jaber]

I have quite a few emission parts here as well. Yavapai Co. dont require it, Yet. Let us know.....

[Mikel]

Here is my low flow cat :thumbsup:

http://img165.imageshack.us/img165/9112/untitled4po2.jpg

[misfittom138]

http://img122.imageshack.us/img122/7570/catcq0.jpg
By misfittom138 (http://profile.imageshack.us/user/misfittom138) at 2008-02-17

[misfittom138]

I have quite a few emission parts here as well. Yavapai Co. dont require it, Yet. Let us know.....

As far as I know the air pump is all I need. The bearings or bushings inside it are shot.