changing NP208 chain....help

[Cowtit]

How do I get the drive chain off the gears? I've split the case and its right there, do I need to remove the gears to get it off? Also, is there an acceptable amount of play in the chain? Or should it not move at all?

[dnixon]

well i pulled the shaft and removed all 200+ needle bearings and removed it that way. You will have some play since the shaft will be able to move since the other half is missing.
Good luck.

[gsmikie]

make sure you check the nylon pads on the shift fork's they wear out if they are not there get new ones

[Cowtit]

I was able to get it off by taking the gear off the shaft for the front driveshaft yoke. I don't know if I'll be able to get the new one on that way though, we'll see. I still have to order it. First, I need to go christmas shopping....ugh! Its nice to have a warm garage I can leave the Jeep in and not have to worry about getting it all done right away in the freezing cold.

[Bob Barry]

Yes, you pull out the front shaft and gear with the chain; try to leave the mainshaft in-place.