Richmond Area - 3 FSJ's at CAP

[Grantshire]

Had not been by Chesterfield Auto Parts (CAP), the U-pull yard in Richmond, VA, in awhile so I popped in today. Here is what's there (some good stuff, too!):

79 J20 with 360, T18 4spd, Dana 20 TC, HD 44 front, Dana 60 rear, 3.73 gears. Front axles is out from under and on the ground (has locking hubs). Truck also has a nice sliding window on the cab.

72 J4000, 6 cylinder, stick shift (don't think its 4 speed), Dana 20 TC, 5 on 5.5" Dana 44 rear axle (if it had had the 5 lug Dana 60 I would have gotten it), drum brake front axle (both axles 3.73 gears), excellent hood with cross bar. Also has home made roll bar with lights.

75 NT 3 door Cherokee, 6 cylinder, 3 speed, Dana 20TC, rust bucket but flat top knuckles on the front 44 (don't know gearing), Warn locking hubs, decent painted 3 piece bumpers.

Go get um..:drivin:

[TealJ]

79 front axle is DSD aint it
Was there a tailgate on that truck?

[Grantshire]

Nope, DSD started in 1980, this one is passenger side. I don't think there is a tailgate on either of the trucks but I did not look in the back.

[HeavyHauler]

I haven't been there in awhile. Looking for a late model GW to pick some
stuff off of.

[My1990GW]

How far off of I-95 is this place and what are the hours? Thanks in advance!

[Grantshire]

CAP is about 20 minutes off I-95 ( about 2 miles off Chippenham Parkway on Rt 60 east). Current hours are 8-5 during the week and close to that on the weekends.

[HeavyHauler]

Best bet would be exit 79 to Powhite Pparkway to Chippenham Pkwy(150)
South. Get off Midlothian Turnpike east & go down the road apiece. When Midlothian veers left, you veer right onto Old Midlothian Turnpike-#5111.
Phone number 804-233-5481.

[TealJ]

Grantshire sent you a PM

[My1990GW]

Thanks to everyone for the directions, hours, and the phone number!!!

[fullsizejohn]

Only one left as of today... the j-20 front axle is gone, the dana 60 is still in it.