Hard Vacuum line at rear of GW

[Darin]

I was wiring up some rear accessory lights last week and noticed one of those small hard vacuum lines disconnected and tucked up in the rear frame. I traced it, but it was un connected on both ends. It has a yellow thread cap type connector on at least on end. I can't tell where this goes or what its for. Any ideas?

[Jim Barbero]

Did a PO perhaps have Air Shocks installed? Sounds like the most probable reason as they come with this type of line.

Jim

[Darin]

AAhhh. that would make sense. When I had new springs built for the rear I had them put on new gas shocks. They mentioned that there were really old air shocks on the rig previously. Looks like a can remove and save the hard vacuum line for other repairs.

Thanks.

[Jim Barbero]

Anytime smile.gif

Jim

[Bob Barry]

Could it also be for the rear wiper fluid? Even if the truck wasn't equipped with that option, Jeep may have installed the hose as a matter of course during construction, so it wouldn't have to be added later.

[Darin]

Bob,

To opperate the ?pump? bak there? I'll look into that as well. I do have the rear wiper option, and was wondering why I don't have fluid back there. (I know why the wiper doesn't work. It was in 4 pieces) :eek:

[Bob Barry]

Yes, the resevoir for the rear wiper washer is under the hood (look under there yourself to see if it is still installed; it looks just like the front one and sits right next to it). I guess there was no place out back to install the resevoir, so they ran a line all the way to the back.