Re-finishing GW Wheels

[jackz4000]

I have 2 sets (8) of the GW factory wheels I would like to re-finish later this spring. They are the original aluminium alloy type and have become kinda dirty and pitted over the years. Also, one set has the gold or copper color trim and whats the best way to remove that trim color. Thanks, Jack

[wrinkledmeat]

Clean strip or another cheap paint remover from Home Depot or the like. Spray the entire wheel. Wait 20-30 minutes. Hose down wheel with a sturdy stream of water. Re-apply if needed. Break out the Mothers or Duraglit and spend some quality time shining it up with a buffing wheel. Apply a quality clear coat. Comes out like a new 'chrome' wheel.

[trssho]

I have a pic in my profile.

[Earthmonster]

Por-15 produces a wheel restoration kit that comes with everything you need to do a full set of rims. My buddie used it on a set of centerline rims with great results. It comes with everything you need- clearcoat stripper, polishing kit, new clearcoat/sealant-- I would check it out- his look like new.

[jackz4000]

Thanks for the help. Should I use a fine grit (like 600) for any stubborn pitting. Also, Should I finish off with a clearcoat? Thanks, Jack

[The Anti-Chrysler]

Refinishing wheels can be really tough. I don't know what part of NE you are in, but in CT there is a place called Keystone, that reapirs / refinishes wheels for a decent price and will also buy junk alum. wheels.

[jackz4000]

Yeah, I haven't found too much info on re-finishing them. Liked Greasemonkey's pic's. I'm in VT, so CT is a stretch. And refinishing them is a nice little project for me to do. Thanks everyone, Jack

[The Anti-Chrysler]

Give it a try and see how it works out. I think Keystone might have other locations in NE, so it could be a back-up plan - although I'm sure you could always throw them in boxes and ship if it was a last resort...