Riverbeast: Shackle kit spring mount question

[Heimeken]

Todd,

I installed the kit today! Awesome. Took me and my dad 7 hours... non stop. One question though. I noticed that the spring mounts where a bit wide for my springs. There's about 1/16 inch on each side of the spring bushings(1/8" total), both on the front mount and on the shackle sode after I tighten the bolds pretty tight. My springs are rough country's with poly bushings. I can tighten it down some more but the mounts will bend. What should I do? should I add some washers as spacers or tighten and bend?

[River Beast]

Sinch them down...tight... then back it off a bit. Sometimes the brackets did 'flex' a bit after a cut and weld... I noticed this on a few...this has since been corrected. No spacers needed.

Anything else, just let me know....

[River Beast]

By the way... you take pics yet? sure would like some.... ;)

[Heimeken]

Thanks Todd, I'll tighten it down see how it flies. I should have pics really soon, just need some final touches.

[Tourettes]

i was wondering, how much does the kit cost?
and how much does it weigh(for shipping)
thinking about one for both my rigs.

[River Beast]

Originally posted by Tourettes:
i was wondering, how much does the kit cost?
and how much does it weigh(for shipping)
thinking about one for both my rigs.Go to the link in my sig for the shackle inversion....

Any questions.... please feel free to ask via email...